Liebherr 7085446-01 manual Control, Setting the temperature, Using the sectioned shelf, Door racks

Control

5.4.2 Setting the temperature

The temperature depends on the following factors:

-the frequency of opening the door

-the room temperature of the installation location

-the type, temperature and quantity of the food

Recommended temperature setting: 5 °C

An average temperature of approx. -18 °C is then established in the freezer compartment.

The temperature can be adjusted continually. Once the 1 °C setting is reached, the sequence starts again at 9 °C .

u Call up temperature function: press the setting button Fig. 2 (4).

w The previously-set value will flash in the temper- ature display.

u Change the temperature in 1 °C steps: Press the setting button Fig. 2 (4) until the required temperature is indicated in the temperature display.

u Change temperature continually: hold down setting button.

w During adjustment the value flashes on the display.

w The new setting is adopted approx. 5 seconds after the last time the button was pressed and the set temperature displayed again. The temperature in the interior gradually adjusts to the new value.

Dismantling shelves

u The shelves can be disman- tled for cleaning.

5.4.5 Using the sectioned shelf

Fig. 3

uThe glass shelf with stop face (2) has to be at the back.

uThe glass plate (1) with pull-out stops must be at the front so that the stops (3) face downwards.

5.4.6 Door racks

Moving the storage rack

5.4.3 Fan*

With the fan you can rapidly cool large quantities of fresh food or achieve a relatively even distribution of temperature across all the storage levels.

The forced-air cooling is to be recommended:

-at high room temperature (above33 °C )

-at high humidity

The forced-air cooling uses slightly more energy. To save energy, the fan switches off automatically when the door is open.

Switching on the fan*

uBriefly press the fan button Fig. 2 (9). w The fan symbol Fig. 2 (10) shines.

w The fan is active. It switches on automatically when the compressor runs.

To switch off the fan*

uBriefly press the fan button Fig. 2 (9). w The fan symbol Fig. 2 (10) goes out. w The fan is switched off.

5.4.4 Shelves

Relocating the shelves

The shelves have stops preventing them from being uninten- tionally pulled out.

u Lift the shelf and draw it out forwards.

u Insert shelf with the raised edge pointing upwards at the back.

w The food does not freeze onto the rear wall.

Fig. 4

Dismantling door racks

Fig. 5

uThe door racks can be dismantled for cleaning.

5.4.7 Using the bottle holder

u To avoid the bottles tipping over, push the bottle holder along.

6 * Depending on model and options