CI_16_CS_16 Use Manual.qxd 1/12/2004 3:08 PM Page 6
OPERATION
To increase the temperature:
Press the UP button on the left to increase the refrigerator temperature (Fig. 1, 8) and on the right to increase the freezer temperature (Fig. 1, 2).
1.While you are entering the temperature, the set temperature will flash on the display.
2.When you press the temperature setting buttons for the first time, the most recent setting (known as the “reference setting”) is displayed.
3.You can change the settings in increments of 1°F (1°C) by briefly pressing the buttons again. If the buttons are held down the temperature setting will change faster.
4.Approximately five seconds after the button has been released, the display will automatically show the actual freezing or cooling temperature (known as the “actual setting”).
5.You can change the temperatures:
•In the refrigerator – between 36°F and 44°F (2°C and 7°C) and
•In the freezer – between
Childproof Lock - Figure 1
The childproof lock is designed to protect the appliance from being turned OFF accidentally.
1.Turning ON: Hold down the Alarm button (Fig. 1, 5) and then press the Superfrost button (Fig. 1, 4). Keep both buttons pressed simultaneously for approximately three seconds.
•A double beep confirms your entry.
•The Childproof Lock Display (Fig. 1, 6) will come ON.
2.Turning OFF: Press this key combination again; the display (Fig. 1, 6) will now turn off.
Temperature Display - Figure 1
In normal operation, the following settings will be displayed:
• the average refrigerator temperature in
display (Fig. 1, 7)
• the warmest frozen food temperature in display (Fig. 1, 1).
When starting up for the first time or when the appliance is warm, dashes will appear until the temperature reaches a level that can be displayed; 32°F to 66°F (0°C to 19°C) in the refrigerator and below 32°F (0°C) in the freezer.
It will take between three and eight hours for the required temperature, 0°F or 41°F
The display will flash:
•if you change the temperature or
•if the temperature rises by several degrees, indicating cold loss, e.g. if you place fresh, “warm” food in the freezer or if you remove or repack frozen food, the temperature may rise for a short time due to warm air flowing into the freezer.
•If “F1”to “F5”appears in the display, the appliance has a fault. Have the fault number available when you contact the customer service department.
Audible Warning Signal - Figure 1
The audible warning signal helps to protect frozen food and to save energy.
• The audible warning will sound when it is not cold enough in the freezer compartment.
•The temperature display will also “flash”when too much warm air enters the freezer compartment when inserting, rearranging or removing frozen food.
•The audible warning signal can be turned OFF by pressing the Alarm button (Fig. 1, 5). The temperature display will continue to “flash”until the cause of the alarm has been corrected.
6 | CI 16/CS 16 |
