Liebherr HCS, 7081 411-01 manual IceMaker, Safety Instructions and Warnings, Bleeding the Ice Maker

Models: CS HC 7081 411-01 HCS

1 26
Download 26 pages 63.32 Kb
Page 20
Image 20
IceMaker

IceMaker

Safety Instructions and Warnings

The Ice Maker is designed exclusively to make ice cubes in quantities needed by a household and may only be operated with water appropri- ate for this purpose.

All repairs and work on the Ice Maker may only be done by customer service personnel or other appropriately trained personnel.

Do not consume or use the first three batches of ice. This applies both to using the appliance for the first time and also using it after it has not been used for a long period of time.

The manufacturer cannot accept liability for damage caused by equipment or water lines between the solenoid valve and the water supply.

The Ice Maker will only work if the combined refrigerator-freezer is connected to the electrical outlet. It will only make ice cubes if the freezer compartment is operating.

The Ice Maker can only make ice cubes if the upper freezer drawer is completely closed and the ice cube bin is installed correctly (Figure 17).

Bleeding the Ice Maker

IMPORTANT

To ensure a proper function of the Ice Maker the water pipe system must be purged of any air.

Turn the Ice Maker on by touching the Ice Maker icon (Figure 21).

Open the top freezer drawer.

Press the button on the Ice Maker housing (Figure 19) for approx. 3 seconds. The LED above the button starts blinking.

Press the button again briefly. The LED blinks faster.

Close the top freezer drawer immediately.

The water intake of the appliance opens for 25 seconds and bleeds all air from the pipe system.

After this the Ice Maker tray (Figure 20) must be emptied. Refer to chapter “Ice Maker at vacations”.

Finally clean the ice cube bin (Figure 17).

To Start the Ice Maker

To turn the Ice Maker on

Touch the Ice Maker icon so the Ice Maker LED comes on (Figure 21).

After you start the Ice Maker for the first time it may take up to 24 hours before the first ice cubes are ready.

Note

The first three batches of ice must not be consumed or used.

The production capacity is 100 - 120 ice cubes in 24 hours at a temperature of 0°F inside the freezer compartment.

To have the maximum capacity of approx. 150 ice cubes in 24 hours, activate the Superfrost function.

Be aware that this increases the energy con- sumption because the compressor will run con- stantly.

The ice cubes fall out of the Ice Maker into the ice cube bin (Figure 17). When the ice reaches a cer- tain level in the bin, the appliance stops producing ice automatically.The ice maker will not fill the bin to the top.

To turn the Ice Maker off

If you do not need any ice cubes, the Ice Maker can be turned off independently of the freezer com- partment.

Touch the Ice Maker icon so the Ice Maker LED goes out.

Note

The Ice Maker can also be turned on and off by pressing the “On/Off” button at the Ice Maker housing for approximately 1 second (Figure 19).

Figure 19

20

Page 20
Image 20
Liebherr HCS, 7081 411-01 manual IceMaker, Safety Instructions and Warnings, Bleeding the Ice Maker, To Start the Ice Maker