3/8 X1"
FIGURE 16
STEP16: | .- ~. |
¯Loop the threaded end of the CABLE(23) throught the holes and around the pulleys in the TOWERBRACE(10) as shown FIGURE16.
¯Screw the treaded end of the: CABLE(23) approximately 3/4" into the end of the WEIGHTSTACKSHAdb'T(19) and tighten nut securely. See FIGURE16.
¯If the HEADPLATE(20) does not sit on top of the first WEIGHTPLATE(54), push the head plate down, insert the SELEC- TORPIN (48) and perform several repetitions on the machine. This will relax the cable system and preatent the HEADPLATE (20) fromlifting up.
¯If after completingthe prex~ious .step the HEADPLATE(20) still does not sit on top of the first WEIGHTPLATE(54) or if there is excess slack in the cable :~ystem, adjust the threaded end of the CABLEaccordingly and retighten the jam nut.
¯Thread two 3/8 X 1" BOLTS(38) and two 3/8" WASHERS(41)
(1)as shown in FIGURE16.
13
