8.Locate the DISPLAY CONSOLE (4). Position the CONSOLE near the top of the CONSOLE BRACKET. Attach all CONNECTORS leading from the CONSOLE BRACKET to their corresponding CONNECTORS in the back of the DISPLAY CONSOLE. Feed any excess WIRE HARNESS into the CONSOLE BRACKET and place the DISPLAY CONSOLE onto the CONSOLE BRACKET aligning the mounting holes. Secure the DISPLAY CONSOLE using four SCREWS (2). Tighten the SCREWS securely. Do not over-tighten the SCREWS.

9.Locate the CONSOLE SUPPORT COVER (8). Position the CONSOLE BRACKET COVER over the underside of the CONSOLE SUPPORT ASSEMBLY (7) as shown and secure it using two SCREWS (2). Tighten the SCREWS securely. Do not over-tighten the SCREWS.

10.Locate the CONSOLE SUPPORT CAP (21). Snap the CAP into position at the top of the CONSOLE SUPPORT COVER.

11.Locate the BASE FRAME CAP (19). Remove the two SCREWS (H) securing the front of the BASE FRAME COVER (J) to the BASE FRAME

(K). Position the CAP over the front of the BASE FRAME as shown sliding the mounting tabs to the inside of the BASE FRAME COVER. Secure the CAP using two SCREWS (H) previously removed. Tighten THE SCREWS securely. Do not over-tighten the SCREWS.

12.Locate the four FOOT COVERS (20). Align the COVERS with the ends of the STABILIZER BARS (L). Insert the post on the underside of the FOOT COVERS into the mounting holes on the top of each STABILIZER. Press the FOOT COVERS firmly into position.

13.With the cross-trainer in the intended location for use, locate the supplied POWER SUPPLY (#11) and LINE CORD (#12). A coaxial broadcast supply line with an F-Type connector (not supplied) is required for entertainment viewing. Connect the POWER SUPPLY CONNECTOR to the appropriate connector located on the front underside of the cross-trainer. Connect the broadcast supply line at this time if available. Connect the LINE CORD to the POWER SUPPLY and plug the LINE CORD into a power outlet.

NOTE: Refer to the OPERATION MANUAL for specific power requirements.

REMARQUE : Reportez-vous au GUIDE D'UTILISATION pour les caractéristiques de l'alimentation électrique.

14.With the cross-trainer in the intended location for use, check the stability of the cross-trainer. If the cross-trainer is not level, turn a LEVELER (M) in the front STABILIZER BAR (L) in either direction until the rocking motion is eliminated. Tighten the JAM NUT (N) when the cross-trainer is level.

NOTE: Only one leveler needs to be turned.

REMARQUE : Ne tourner qu’un seul vérin.

21

2

7

 

4

 

 

 

 

 

 

1

17

 

 

 

 

2

1

83

G

F

H19 K

20 M N L J

12 11

Page 6
Image 6
Life Fitness 93Xe manual K N L J