Life Fitness 22. Plug in and power on the TV. Refer to the Owners Manual for proper TV setup., 12

9. Tilt the DISPLAYCONSOLE (--) forward and connect
the I-R CONTROL(A) and S-VIDEO (--) CABLES to
the back of the DISPLAYCONSOLE.
10. Tape the ends of the all CABLES (POWER,
COAXIAL, I-R CONTROL, S-VIDEO) together.
11. Feed the taped end of the MEDIA CABLES (--)
through the large hole in the back of the CONSOLE
BRACKET (--). Carefully pull excess MEDIA CABLE
through the CONSOLE BRACKET .
12. Slide one GROMMET (--) over the taped end of the
MEDIACABLES (--).
13. Holding the MAIN BRACKET ASSEMBLY(--) close to the
CONSOLE BRIDGE (--) as shown. With the holes facing
upward, feed the taped end of the MEDIACABLES (--)
through the BOTTOM LARGE HOLE of the MAIN BRACK-
ETASSEMBLY and out of the UPPER HOLE as shown.
Carefully pull excess MEDIACABLE through the MAIN
BRACKETASSEMBLY.
14. Slide the remaining GROMMET (--) over the taped end of the MEDIA CABLES (--). Install the
GROMMETS into the ACCESS HOLES.
15. Secure the MAIN BRACKET ASSEMBLYusing four SCREWS (--) and WASHERS (--) as
shown. Tighten the SCREWSsecurely. (8-10 ft. lbs.)
16. Install the MAIN BRACKET CAPS (--) to the top and bottom of the MAIN BRACKET
ASSEMBLY(--).
17. With the remaining TV BRACKET (--) oriented as shown, install it to the back of the
TV (--)using four SCREWS (--) and WASHERS (--). Tighten the SCREWS
securely. (8-10 ft. lbs.)
NOTE: Be sure the side holes of the TV BRACKET are oriented as
shown.
18. Position the TV BRACKETS (-- & --) together as shown below and
secure them together using one BOLT(--), WASHER (--) and NUT (--).
Leave the BOLTand NUT loose at this time.
NOTE: Be sure the PIVOT POSTof the TV BRACKET (--) engages onto
TV BRACKET (--).
19. Remove the tape from the end of the MEDIA CABLES (POWER,
COAXIAL, I-R CONTROL, S-VIDEO). Connect all cables to their corre-
sponding jacks located on the back of the TV (--) (See end of instruction man-
ual for TV connection details). Feed any excess MEDIACABLE into the MAIN
BRACKET (--).
20. Tilt the DOSPLAY CONSOLE back into place. Replace the REAR CONSOLE
COVER (--) and secure it using the previously removed six SCREWS (--).
Tighten the SCREWSsecurely. (8-10 ft. lbs.). Do not over-tighten the
SCREWS.
21. Align the LOWEST SIDE HOLES on the TV BRACKETS (-- & --).
Secure the TV BRACKETinto proper position using one SCREW (--
) on each side.
NOTE: Life Fitness recommends aligning and securing the TV
at the lowest side holes ????(--) as shown.
22. Plug in and power on the TV. Refer to the Owners
Manual for proper TV setup.
INSTALLATION
12
A
AAA
A A
A
A
A
A
A
A
A
A
A
17
6
15
16
22
4
16
8
D