Life Fitness 95T operation manual Power Cord Routing

POWER CORD ROUTING

WARNING: Make sure the power cord is unplugged before attempting to route it around or through the treadmill.

The POWER CORD (A) can be run to the user-front left or right sides. Excess POWER CORD can be bundled and tied to the pre-installed CLIPS (B) located under the front of the treadmill.

The POWER CORD (A) can be run to the rear of the treadmill through the LEFT SIDERAIL (C). The POWER CORD should run under the LEFT UPRIGHT COVER and into the internal channel of the LEFT SIDERAIL as shown.

NOTE: To accommodate treadmill incline, at least two feet (24”) of POWER CORD is required between the outlet and the last power cord CLIP (B) for outlets in front of the treadmill.

WARNING: Make sure that there is a 6-foot clearance behind the treadmill. Contact Life Fitness Customer Service for an optional longer power cord if necessary.

DANGER: Insure that the power cord (A) does not contact the striding belt or get pinched between the frame (D), lift arm (E) or under the wheels (F); failure to follow this warning may result in serious injury.

AVERTISSEMENT: S'assurer que le cordon d'alimentation n'entre pas en contact avec le tapis et ne

soit pas pincé entre le cadre, le bras de levage ou la roue. Le non-respect de cet avertissement peut provoquer de graves blessures.

12