965101 FLAT & INCLINE BENCH ASSEMBLYINSTRUCTIONS

1.Slide one (1) 7/16 ID X 4 IN VINYLCAPonto the 6-1/8X 3-7/8 IN U-PINand proceed to assemble it to" the BENCHFRAMEWELDMENTas shown on drawing.

Insert two (2) 3 X 2 INSEP~TGUIDESinto each end of the ADJSLEEVEWELDMENTas shown

drawing. (NOTE: MAKESURE THE INSERT GUIDES SNAP INTO THE HOLES OF THE WELDMENT).SECURELYassemble the SPRING PIN ASSEMBLYto the ADJ SLEEVE WELDMENTas shown in (DETAIL A).

o

Pull back the SPRINGPIN on the ADJSLEEVEWELDMENTand slide it over the end of the BENCH FRAMEWELDMENT~ shown on drawing. Slide WELDMENTup to the flu-st adjustment hole underneath.

Insert three (3) 3 X 2 IN ENDCAPSinto the ends of the REARUPRIGHTWELDMENTas shown drawing.

o

SECURELY assemble ~e REAR UPRIGHT WELDMENTto the BENCH FRAME WELDMENTas shown on drawing.

Assemble the LEFT and .RIGHT BACKPAD ANGLEWELDMENTS,along with two (2) H1NGE TABS to the BENCHFtL~ME WELDMENTas shown on drawing. (NOTE: TIGHTEN CONNECTION ENOUGH TO REMOVE THE PLAY YET ALLOWING THE PARTS TO ROTATE FREELY).

Assemble two (2) 1/2 X 2 X 15-1/2 IN PLATESto the inside of the LEFTand RIGHTBACKPAD

ANGLE WELDMENTSas shown on drawing. (NOTE: TI(;HTEN CONNECTIONENOUGH REMOVETHE PLAY ~'ET ALLOWINGTHE PARTS TC, ROTATE FREELY).

Rotate the LEFT and RIGHTBACKPADANGLEWELDMENTSup and assemble the 1/2 X 2 X 15- 1/2 IN PLATES to the ADJ SLEEVEWELDMENTas shown on drawing. (NOTE: DO NOT OVER TIGHTEN THIS CONNECTION).

Part # 6653501

Revision: 1 ]/26/96

Page 7
Image 7
Life Fitness 965101 manual Flat & Incline Bench Assemblyinstructions