Life Fitness 965101 manual Flat & Incline Benchassemblyinstructions

965101 FLAT & INCLINE BENCHASSEMBLYINSTRUCTIONS

1.Slide one (1) 7/]L6 ~ X 4 ~ ~ C~ onto ~e 6-1/8 X 3-7/8 ~ U-P~ ~d proceed to am;emble it

~e BENC~ FR~ ~LD~NT ~ sho~ on ~w~g.

Insert two (2) 3 X 2 INSERTGUIDESinto each end of the ADJSLEEVEWELDMENTas .,;hoxvn

drawing. (NOTE: MAKESURE THE INSERT GUIDES S NAP INTO THE HOLES OF THE WELDMENT)..SECURELYassemble the SPRING PIN ASSEMBLYto the ADJ SLEEVE WELDMENTas shown in (DETAIL A).

o

Pull back the SPR.INGPIN on the ADJSLEEVEWELDMENTand slide it over the end of ~ae BENCH FRAMEWELDMENT,as shown on drawing. Slide WELDMENTupto the f'ast adjustmenl ~. hole underneath.

Insert three (3)'3 X 2 IN ENDCAPSinto the ends of the REARUPRIGHTWELDMENTa:; shown drawing.

SECURELYa.~;semble the REAR UPRIGHT WELDMENTto the BENCHFRAMEWELDMENTas shown on drawing.

Assemble the LEFT and RIGHT BACKPAD ANGLEWELDMENTS,along with two (2) HINGE TABS to the BENCHFRAMEWELDMENTas shown on drawing. (NOTE: TIGHTEN CONNECTION ENOUGH TO REMOVE TIlE PLAY YET ALLOWING THE PARTS TO ROTATE FREELY).

7°Assemble t~vo (2) 1/2 X 2 X 15-1/2 IN PLATESto the inside of the LEFTand RIGHTBACKPAD

ANGLEWEL'I)MENTS as shown on drawing. ('NOTE: TIGHTEN CONNECTIONENOUGH

REMOVE"lille PLAY ~rET ALLOWINGTHE PARTS TO ROTATE FREELY).

Rotate the LEFT and RIGHTBACKPADANGLEWELDMENTSup and assemble the 1/2 X 2 X 15- 1/2 IN PLATESto the ADJ SLEEVEWELDMENTas shown on drawing. (NOTE: DO NOTOVER TIGHTEN TI]~S CONNECTION).

Part # 6653501 3 Revision: 11/26/96