Service Kit Instructions
How To…Install Wax Lift PCB on Next Generation Treadmills
Installation Kit
1.Turn the unit power OFF at the switch, then unplug the line cord at the wall outlet.
2.Remove the motor cover and front cover.
3.Remove the motror controller mounting screws and slide the motor controller back to gain access to the wax lift board mounting screws and electrical connectors.
Motor Cover
Front
Cover
Motor Controller
Wax/Lift PCB
4.Disconnect all connectors from the Wax Lift Board.
5.Remove three phillips mounting screws from the PCB and remove.
6.Install the new PCB in the reverse order.
