Smith Machine PL06 Unpacking & Assembly Instructions
7.Insert the bar into the left side carriage. Repeat Steps 5 and 6 above for the left side carriage. Remove the carriage bolts and slide the left bar carriage onto the bar and secure it to the sliders. Loosely tighten the hex cap screws using a 5/32” hex key and 3/8” combination wrench.
8.Secure the cables to the carriages. The cables are attached with cable nuts (see Assembly Figure 8). Hold the bar on your shoulder as shown in Assembly Figure 7 and twist it out of the hook plate. With the bar around chest height (or lower), use a 7/8” combination wrench to tighten the cable nuts to the cables as shown in Assembly Figure 8.
Assembly Figure 7. Remove the bar from the hook plate.
Assembly Figure 8. Tighten upper and lower cable nuts.
Repeat this step for the other side of the carriage.
10
