SM61 Unpacking & Assembly Instructions
12
INSTALLING THE CABLES
The SM61 uses six cables. There are three different types of cable used on the SM61. They
are:
1. Adjustable crossover cables (ball end cables) (2).
2. Lat pulldown and tricep cables (4).
The lat and tricep cables can be identified by their short length, the low row cables can be
identified by their long length and the adjustable crossover cables can be identified by the ball
on the end of the cable. The routings for these cables are shown in Figures 15, 16, 17 and 18
below.
NOTE: YOU MUST REMOVE ALL PULLEYS TO ROUTE THE CABLES.
USE A 9/16” COMBINATION WRENCH AND SOCKET TO DO THIS
(SEE FIGURE 16). YOU MAY WISH TO REMOVE THE SHOULDER
BOLTS (FIGURE 16 RIGHT SIDE) BY USING A 3/8” COMBINATION
WRENCH AND A 1/8” HEX KEY WRENCH. WHEN YOU HAVE
ROUTED THE CABLES, REPLACE ALL PULLEYS AND PLACE
END CAPS ON NUT AND BOLT ENDS. YOU MAY NEED TO PRY
THE PULLEY HOUSINGS OPEN TO REPLACE THE PULLEYS.
Figure 15. Removing the pulley bolts.