SM63 Unpacking & Assembly Instructions
8
4. Using a 5/8” socket and combination wrench, mount the 56” lat tops (part T from
HARDWARE section) to the cells by inserting two of the large 7/16” by 6” bolts using
the hardware configuration shown in Figure 8. Mount the 29” tricep top (part U in
HARDWARE section) and adjustable crossover top (part V in HARDWARE section)
to the frame and connecting beam (See Figure 7). You will need to remove the
teardrop pulleys from their housings to gain clearance for the socket extension used
to tighten the bolts on the tops. Use a 9/16” socket and combination wrench to do
this.
7/16” x 6” (6)-
mount on tops
3/8” x 3” (2)-
bolt top
beams together
3/8” x 3” (2)-
bolt top
beams together
Remove pulleys from
housings to give clearance
to socket extension
Figure 7. Mount lat tops (T), tricep top (U), adjustable crossover top (V).
Figure 8. Configuration for 6” bolts.