SM80 Unpacking & Assembly Instructions
18
The parts shown in Hardware Figure 1 are used to assemble the SM80. They are:
A. 7/16” x 6” hex head bolt (used to bolt the tricep top beams, lat top beams, and
connecting beam to the tops of the cubes)
B. 7/16” flat washer
C. 7/16” cap washer (used on the head end of the 6” bolt so end cap will fit on the nut)
D. 7/16” hex head nut
E. 3/8” x 3” hex head bolt (used to bolt the tricep pushdown beams to the connecting
beam)
F. 3/8” x 2-3/4” hex head bolt (used for all other connections)
G. End caps (bolt covers)
H. 3/8” flat washer
J. 3/8” end cap washers (end caps snap onto them)
K. 3/8” Nyloc (locknut)
The part shown in Hardware Figure 2 is the 9/16” cable jam nut that’s used to secure the
cables to the weight stacks.
Hardware Figure 2. Cable jam nut.
M. Cable jam nut
Hardware Figure 3 shows the types of cables that are included with the SM80.