Life Fitness WLE-POE-S manual Safe Splitter Z, Fully Seats Into the Ergo Crossbar Gaskets

8.Secure the ERGO CROSSBAR of the HANDRAIL/BRIDGE ASSEMBLY (5) to the CONSOLE BRACKET (6) using three SCREWS (31) and three WASHERS (8).

NOTE: ROUTE THE HEART RATE CABLES (L) UNDER THE MOUNTING TABS AS SHOWN BELOW. BE CARE- FUL NOT TO DAMAGE THE HEART RATE CABLES.

9.From under the HANDRAIL/BRIDGE ASSEMBLY (5), install the MASTER WIRE HARNESS (9) to the CON- SOLE (D) and HEART RATE (L) CABLES. WIRE-TIE

(M) the cables to the CONSOLE BRIDGE as shown.

Feed the combined connector upward to the back of the CONSOLE BRACKET (6).

Attach the FERRITE (W) to the inside of the user left CONSOLE BRACKET POST (X).

31

8

5

	Carefully secure the MASTER WIRE		N
		5
	HARNESS to the CONSOLE BRACKET					L		W
	using CABLE TIES (32)		L
10.	Connect the BASE C-SAFE CABLE (G) to			6					X
	the single port end of the C-SAFE SPLIT-
	TER (Z). Connect the C-SAFE EXTENSION
	CABLE (Y) to one of the two ports of the C-									5
	SAFE SPLITTER (Z).
11.	Slide the TOP COVER (10) over the CONSOLE BRACKET (6)
	and onto the CONSOLE BRIDGE (5). Secure it using
	six SCREWS (7). Tighten the SCREWS secure-
	ly.	10	M	G	H	Z	Y	9	D	E

NOTE: BE SURE THE TOP COVER

FULLY SEATS INTO THE ERGO

CROSSBAR GASKETS.

12. Install three SCREWS (7) in the three for-

ward-most holes of the OUTER HANDRAIL	5
	6
COVERS as shown. Tighten the SCREWS
securely.

NOTE: ONE SCREW IS LOCATED AT THE	7
FRONT OF THE UNIT FOR EACH OUTER
HANDRAIL COVER.
13. Locate the RIGHT INNER HANDRAIL COVER
(11). Align it onto the RIGHT HANDRAIL of the
HANDRAIL/BRIDGE ASSEMBLY (5) as shown
and secure using five SCREWS (7). Tighten the
SCREWS securely.	7

11 5

NOTE: BE SURE TO ENGAGE THE TOP TABS UNDER THE	7
PLASTIC RAIL OF THE RIGHT HANDRAIL.

Repeat for the LEFT INNER HANDRAIL COVER (12).

7