GETTING STARTED
WEARING THE TRANSMITTER BELT
To ensure a proper heart rate detection, the chest transmitter must be moistened and properly fitted.
|
|
|
| 1. Snap the plastic tabs at the end of the |
|
|
|
| adjustable strap into the holes at the end of |
|
|
|
| the transmitter. |
|
|
|
|
|
|
|
|
| 2. Moisten the electrode areas |
|
|
|
| |
Electrode areas |
| |||
| the right and left on the back side of the | |||
|
|
|
| transmitter |
|
|
|
|
|
|
|
|
|
|
3.Adjust the strap so the transmitter fits tightly below the pectoral muscles with the LifeSource logo centered on the sternum as shown in the picture.
6 |
| |
Toll Free LifeSource Health Line | ||
GETTING STARTED
4.Wear the wrist receiver as you would any wrist watch. Keep the wrist receiver and the transmitter within 3 feet/1 meter of each other. You can also attach the wrist receiver to the bike handlebar bracket included in the package.
1.In dry and cold climates it may take a few minutes of use for the electrodes to soften and a layer of perspiration to form between the contact and the skin for good performance. Moistening the elec- trodes with saliva or conductive gel can speed up this process.
2.To ensure the most accurate operation we recommend wearing the chest transmitter against your bare skin. Users with a lot of chest hair may have a problem getting contact between the transmitter electrode areas and their skin, resulting in poor performance. Because of this it may be necessary for these individuals to shave the area of their chest beneath the transmitter.
3.Do not use water, moisturizing creams or suntan oil, as these are insulators and will inter- fere with the heart rate signal.
Toll Free LifeSource Health Line
