| INSTRUCTION SHEET NO. | ||||
INSTALLATION PROCEDURE FOR: | |||||
| IS:1101F | ||||
(Continued) |
| ||||
Lytecaster® 1101F, 1001F and 2001F Series |
|
|
|
| |
|
| D1007 |
| Page 2 of 3 | |
|
|
|
|
| |
|
|
|
|
|
INSTALLATION INSTRUCTIONS FOR WOOD FRAME CEILING APPLICATIONS
1PREPARATION: Remove Wing Nuts on
NOTE: The Mounting Bars may be readily adjusted to fit openings between 13” (330mm) minimum and 24” (610mm) maximum. With modification the Frame may be installed in openings as small as
2POSITION AND INSTALL LUMINAIRE FRAME: Position Luminaire Frame between joists with the End bracket at one end placed against, and flush to the bottom of, the joist (Figure B). When positioned, hammer the integral nailing tabs at both ends of the End bracket into the joist (Figure C). Extend the End bracket at the opposite end of the Luminaire Frame until it contacts the opposite joist. Align and attach. The frame can be fully secured by driving a nail or screw through any of the holes provided at each end of the End bracket. Slide the Luminaire Frame along the Mounting Bars until the aperture is in the desired position and lock the Frame in place by tightening the Wing Nuts on the Frame Clamps.
NOTE: When the Luminaire Frame is to be used with Wall Wash Trims make sure to orient the Luminaire Frame side indicated by a label on the frame towards the wall to be illuminated.
*INSTALLATION OPTION FOR REGIONS USING STRAPPING: The Luminaire Frame may be installed directly to strapping as above by screwing the end bracket to the strapping using the hole provided. Nailing Tabs are not used. The upper end bracket tabs (Figure D) may be bent 90˚ to support the luminaire frame on top of strapping.
Optionally, the Luminaire Frame may be attached to the joists between strapping, and positioned 5/8” lower to account for the strapping thickness, by bending the lower end bracket tabs 90˚ as shown (Figure D) with a pair of pliers. These bent tabs may now be used to position the Luminaire Frame vertically with reference to the joists so that the frame is flush to the strapping. Attach the Luminaire Frame to the joists as described above (Figure E).
Figure C
Figure A
Figure B | Figure D | Figure F |
|
*INSTALLATION IN SPACES BETWEEN
A COMPANY
631 Airport Road, Fall River, MA 02720