![](/images/new-backgrounds/1028299/282991x1.webp)
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.
This fixture is intended for installation in accordance with the National Electrical Code and local or Federal code specifications. To assure full compliance with codes and regulations, check with your local electrical inspector before installation. To prevent electric shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:1102TH1R
B0600 | Page 1 of 2 |
INSTALLATION PROCEDURE FOR REMODELER KITS 1102TH1R, 1102TH2R
FOR USE WITH 1102T SERIES TRIMS ONLY
MAXIMUM CEILING THICKNESS - (1) INCH
WARNING: (RISK OF FIRE) DO NOT INSTALL INSULATION
WITHIN 3” OF FIXTURE SIDES OR WIRING COMPARTMENT,
NOR ABOVE FIXTURE IN SUCH A MANNER SO AS TO
ENTRAP HEAT
Fig. A
1.CUT OPENING (Fig.A)
Use aperture sticker provided as a template to cut a hole in the ceiling. Cut to outside edge of sticker.
2.WIRE- IN (Fig. B)
WHITE FIXTURE LEAD to NEUTRAL SUPPLY LEAD; BLACK FIXTURE LEAD to HOT (120V) SUPPLY LEAD; BARE FIXTURE WIRE to SUPPLY GROUND. Use wirenuts (local hardware item). Place all electrical connections in the
3.ATTACH J-BOX (Fig. C, D, & E)
1.Place
2.Push LONG LEGS of NAIL CLIPS (supplied in parts bag) into RAISED BUMP of
|
|
| RAISED |
|
|
| |
Fig. C |
|
| BUMP |
|
| ||
|
|
| NAIL |
|
| Fig. D | TAB |
NAIL CLIP LONG LEG
Fig. B
THERMALLY
PROTECTED
BALLAST
PLATE
NAIL CLIP SHORT LEG | Fig. E |
LIGHTOLIER a GENLYTE THOMAS company
631 Airport Road,Fall River MA 02720
© 2000