Lightolier instruction sheet IS 1104IC, E1204, LIGHTOLIER a GENLYTE company, New Construction

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To assure full compliance with local codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

INSTRUCTION SHEET NO.

IS:1104IC

E1204 Page 1 of 2

INSTALLATION PROCEDURE FOR CONVERTIBLE IC/NON ICFRAME-IN-KITS 1004IC, 1104IC, 1004SIC, 1104SIC

NEW CONSTRUCTION

Fig. A	Fig. B	Fig. C
	Wire-In	Swing-Up
Frame-In

Fig. D	Fig. E	Fig. F
Close-In	Snap-On	Push-Up

For IC Installations:

Remove the peel off label on the

outside of the housing

section.

CONVERTIBLE IC/NON-IC HOUSING

IC APPLICATIONS: REMOVE THIS WARN- ING LABEL. SEE INSTRUCTION SHEET.

NON-IC APPLICATIONS: WARNING - RISK OF FIRE.

DO NOT INSTALL INSULATION WITHIN 3 INCHES OF FIXTURE SIDE OR WIRING COMPARTMENT NOR ABOVE FIXTURE IN SUCH A MANNER TO ENTRAP HEAT.

For Non-IC Installations: SOCKET CUP

Remove the lower portion of the ROUGH-IN LABEL as shown. Non-IC rough-in sections are listed for higher wattage lamps.

ROUGH-IN LABEL

1.FRAME-IN (Fig. A)

Locate fixture along joist and line up bottom edge of HINGED MOUNTING BAR with the bottom of joist and fasten in place.

Hinged Mounting Bar

For suspended ceilings:

•Rotate HINGED BAR ENDS to position shown and fully extend bars.

•Crimp bottom of edge of CHANNEL to prevent rotation of HINGED BAR ENDS.

•Bend NON-HINGED end of mounting bar at featured hole location and extend out.

•Position notched area of MOUNTING BARS onto T-BAR and lock by bending TAB underneath T-BAR BEAD as shown.

HINGED BAR ENDS	T-BAR
CHANNEL
3” 1004IC	TAB
3 3/4” 1104IC
BEND AT HOLE	TAB
5 1/4” 1004IC
6 1/4” 1104IC

BEND TAB

TO LOCK

LIGHTOLIER a GENLYTE company.

631 Airport Road, Fall River, MA 02720