InSinkErator 2200 Installing The Faucet, Make sure to use rubber O-ring to ensure proper seal

Unpack dispenser components.

2

INSTALLING THE FAUCET

AQ

Q On a firm, flat surface, carefully straighten the copper tubing.

Property Damage: Do not pinch or break copper tubing. Do not distort the last 1 inch of tubing.

B

QEnsure that the black O-ring is properly seated in the base of the dispenser head (the groove on the underside of the dispenser).

Make sure to use rubber O-ring

to ensure proper seal.

C

An assistant may be needed to hold

the dispenser head in place while securing the dispenser.

QFeed tubes down through the hole in the sink or countertop until the base is at rest on the sink or countertop surface.

D

Semi-circular mounting plate should

encircle all descending tubes and

extend beyond sink hole when tight.

QFrom under the sink, place the semi-circular mounting plate onto the threaded stud.

QPlace hex nut onto the threaded stud. Ensure faucet head is at desired angle.

QInsert screwdriver into hole on side of hex tool (creating a “T”), and use tool to tighten nut and secure faucet.

7