InSinkErator 2200 owner manual Care and USE, Adjusting the Thermostat

CARE AND USE

Electric Shock Hazard: To prevent electrical shock, disconnect power before servicing unit. Use only a properly grounded and polarized electric outlet.

ADJUSTING THE THERMOSTAT

Factory temperature pre-set is 200˚F.	approx. 200°
To reset the thermostat to 200°,
turn the indicator one notch to the
right of vertical.

Q Adjust the thermostat slowly, turning the dial clockwise

to increase temperature or

counter clockwise to decrease temperature, then activate faucet handle for 20 seconds to bring in fresh water to be heated at the new setting. Allow 5-7 minutes for water to reach new temperature.

Scalding Hazard: Do not allow water to boil. May result in severe burns.

SEASONAL STORAGE/DRAINAGE

Anytime the instant hot water dispenser is not used for extended periods of time, unplug and drain unit. If it is below freezing you will need to unplug the unit and drain it.

QDisconnect power from unit.

QPush hot water dispenser faucet lever and allow water to flow until it is cool.

QShut the cold water supply off at the valve.

QIf drain screw equipped, locate and remove from bottom center of water tank and drain the water into empty pail.

Q Empty the tank and then reinstall drain screw onto the bottom of tank, turning until snug. Do NOT over tighten.

QIf drain screw not equipped, disconnect water supply tubes, remove tank and invert to drain. Remount tank.

QRemove and drain filter cartridge. Reinstall.

QTo place back in working order, fill tank with water and re-connect the plug.

CLEANING THE FAUCET AND TANK

QOnly use mild cleaners to clean the faucet and plastic components.

QCleaners with acids, abrasives, alkaline or organic solvents will result in deterioration of the plastic components and void the warranty.

FILTER GUIDE AND REPLACEMENT

Replace filter cartridge when there is an obvious decrease in water flow to the faucet or if there is an objectionable taste or odor to the water.

When the inlet and outlet ports have been closed and the filter’s internal pressure has been relieved, water (about 2 oz) will discharge from vent line.

If the new filter cartridge cannot be inserted, insert the old one and turn until it stops, remove it and then retry the new cartridge.

Carbon filters should be replaced within 12 months.

Filter replacement instructions:

QReplace with an InSinkErator® filter.

QPlace pan or dish towel under the filter to catch water drainage during change.

QSlowly turn the cartridge counter-clockwise completely until it stops (1/4 turn).

QPull cartridge straight down and discard.

QInsert new cartridge into filter head.

QTop surface of cartridge will become flush with the bottom of the filter head when fully engaged.

QTurn the cartridge clockwise until it stops (1/4 turn).

QAlign the in/out arrow on the head and bracket assembly to the in/out arrow on the cartridge.

QOpen faucet to expel trapped air.

QRun water for 3 minutes before usage.

PROPERTY DAMAGE

QRegularly inspect the unit for any signs of leakage. If there are signs of water damage, immediately remove the unit from service.

QTo avoid water damage from leakage, replace all cut, loose or split tubing.

QA drain pan, plumbed to an appropriate drain or outfitted with a leak detector, should be used in those applications where any leakage could cause property damage.

12