START HERE PROPER INSTALLATION SHOULD TAKE ABOUT 2-4 HOURS
1 |
| PREPARATION | |
A | Required minimum from | ||
|
| center of hole to wall | |
|
| 31⁄8" | |
|
| 37⁄8" | |
|
| 31⁄8" | |
|
| 37⁄8" | |
|
| 31⁄8" | |
|
| 43⁄8" | |
|
| Maximum counter | |
|
| thickness is 3". |
|
|
|
|
|
QIdentify locations for the dispenser faucet, tank and filter.
QCheck to make sure there is proper clearance for dispenser handles to be fully opened.
QCheck to make sure counter is 3" thick or less.
QMake sure there is a grounded electrical outlet under the sink.
The wall outlet for your dispenser must have power supplied to it continuously and must be fused. It should not be controlled by the same wall switch
that operates your disposer.
B
If you have to drill through sink or
countertop, you may need to rent or purchase
the appropriate tools.
QTurn off water supply.
QIf using the sink sprayer hose hole, remove nut that connects sprayer hose at bottom of faucet.
QUsing adjustable wrench, remove nut connecting sprayer washer flange in sprayer hole.
QPlug hose opening with either a 1/8" plug or a 1/4" cap (not supplied).
C
Required Hole Size
Hot & Cool Models | 13⁄8" - 11⁄2" |
Hot Only Models | 11⁄4" - 11⁄2" |
Consult a professional before drilling into
a surface other than stainless steel.
What if you don’t have a sprayer hole or don’t want to use it?
QMany homeowners replace the soap dispenser in their sink with an instant hot water dispenser.
QIf drilling a hole into a stainless steel sink or counter top, you can cut a mounting hole for the dispenser with a hole saw for stainless steel, or you can use a hole punch.
6
