InSinkErator 2200 owner manual Final Water Connection, Water will be cold at first

6

FINAL WATER CONNECTION

A

Brass Nut

Ferrule

Brass Insert

Plastic tube

Property Damage: Join remaining tube

to cold water supply only.

QInstall a T-fitting (not included) onto the cold water supply line.

QInstall dedicated water control valve with 3/8" compression fitting.

QAt the end of the white 3/8" tube from the filter or quick-connector, slide the supplied brass nut and ferrule over the tube and then push in the brass tube insert.

QInsert the white 3/8" tube into the 3/8" compression fitting and tighten.

B

Scalding Hazard: The faucet dispenses near-boiling (212ºF) water which can instantly cause scalds or burns. Use care when operating this appliance.

QTurn on the cold water supply.

QDepress the dispenser’s HOT handle and hold it until water flows from the spout.

QRun the water for at least 2 minutes to flush lines (both the hot and cold handles independently if applicable).

C

Property Damage: A standard grounded outlet within 30" of the dispenser is required under the sink. Do not use an extension cord set with the dispenser.

QCheck all connections to ensure they are tight and that there are no leaks.

QPlug in instant hot water tank.

Water will be cold at first.

Allow 12-15 minutes for water to reach target temperature.

Gurgling or hissing is normal during the initial heating cycle.

If the water coming from the faucet is not hot 15 minutes after the unit has been plugged in – or for other issues related to the operation of your instant hot water dispenser – refer to the “Troubleshooting” section on Page 14.

10