Lightolier manual Page 2 of, Lytespan Track Lighting9100, Radius Track 1 Circuit Track, Type

Page 2 of 4

Lytespan® Track Lighting  9100

Radius™ Track 1 Circuit Track

Direct Mounting

Toggle Bolts and Nylon Insulators are furnished with the Track: 2 per 2', 4', and 6', 3 per 8'. Mount toggles through existing holes in track. Top of track is flush to ceiling. Recommended for wall and ceiling mounting.

Additional supports may be required when wall mounting or when using heavy lighting fixtures on the Radius track.

Nylon Spacer

Toggle Bolt

Suspended Grid Ceiling Mounting Clips Square Edge Panels and 9/16" - 15/16" T-Bars

Clip attaches at any point along a straight section of T-Bar by rotating the clip. Pass clip stud through existing holes in track and secure with nut.

Junction Box Cover

Mounts above "L" feed 9155WH,BK or "T" 9151WH, BK. Mounts to a 4" or 3" octagon outlet box. Direct mount track to surface. Canopy is 3/32" thick and 4-1/2" square.

9060WH Matte White

9060BK Matte Black

Live End Canopy

Mounts directly under a 4" or 3" octagonal outlet box. Live End Canopy attaches mechanically to the J-Box. The canopy is polarized (meaning the connector goes into the track one way, providing consistent alignment of the neutral and hot wire connections with the track

and lighting fixtures). 9160WH Matte White 9160BK Matte Black

Outlet Box (by others) Supply Leads

Ground Wire

Canopy

3/23"

4-1/2"

Slot

4-1/2"

Screw

Centerline

J-Box

Additional supports may be required when supporting heavy lighting fixtures on the Radius track.

9189 (9) Clips

T-Runner

Square

Edge Panel

GND NEUT

4 3/8"

Square

Track Unit

9/16" - 15/16"

1/2"

3/16"

Canopy

Regressed Edge Panel Mounting Clips

9/16" - 15/16" T-Bars

Clip attaches at any point along a straight section of T-Bar by rotating the clip. Pass clip stud through existing holes in track and secure with nut.

Additional supports may be required when supporting heavy lighting fixtures on the Radius track.

9188 (9) Clips

T-Runner

Regressed

Edge Panel

Saddle Canopy Kit	Track Unit
Mounts anywhere along the track (excluding
track mounting hole locations) for power feed
from a 4" or 3" octagon box. Track must be
mounted at 45ϒto the mounting holes when
using a 3" J-Box. Max load 20 amp. at 120V
60Hz.
9163WH Matte White
9163BK Matte Black
Dead End Cover

45ϒ

3" Octagon J-Box (by others)

9/16"-

15/16" 5/16" - 13/32

	4-1/2"
	square	Electrical Fitting
	Job Information	Type:
		Canopy Cover
1-3/16"	631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710
	We reserve the right to change details of design, materials and finish.
	www.lightolier.com © 2008 Philips Group • C0808

Lightolier is a Philips group brand