Lightolier A0302 instruction sheet IS7784, Instruction Sheet no

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To

assure full compliance with local codes and regulations, check with your local electrical inspector before

installation. To prevent electric shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

INSTRUCTION SHEET NO.

IS:7784

A0302 Page 1 of 3

INSTALLATION PROCEDURE FOR ELLIPSOIDAL DOWNLIGHT (A-LAMP)

CAUTION: (RISK OF FIRE) DO NOT INSTALL INSULATION ABOVE, NOR WITHIN 3 INCHES (76mm) OF ANY PART OF

THE LUMINAIRE.

FIG. 1

A. INSTALL MOUNTING FRAME IN CEILING USING ADJUSTABLE MOUNTING BRACKET

(1) With MOUNTING BARS (order separately): (2) With ¾” channel (by others)	(3) With 1 ½” channel (by others)
18” – Cat. No. 1950; 27” – Cat. No 1951).
Use rectangular slots as shown.

FIG. 2 FIG. 3 FIG. 4

Slide MOUNTING BARS or CHANNELS (by others) through slots in ADJUSTABLE MOUNTING BRACKET which will place the bottom of the MOUNTING FRAME approximately in line with the finished ceiling line. Final adjustments may be made by means of MOUNTING BRACKET SCREWS on inside of fixture.

For wood joist construction: TELESCOPING MOUNTING BARS No. 7994 (order separately) may be used to secure MOUNTING FRAME (Fig.5).

TELESCOPING

MOUNTING BARS

FIG. 5

For suspended ceilings: T-Bar ANCHOR CLIPS ACCESSORY No. 1956 (order separately) may be used with 18” or 27” MOUNTING BARS or TELESCOPING MOUNTING BARS for quick mounting (Fig. 6) or simply wire MOUNTING BARS to ceiling members (Fig. 7)

MOUNTING	T-BAR ANCHOR	WIRE
BAR	CLIPS
	ACCESSORY
	MOUNTING
	BAR
FIG. 6		FIG. 7

A COMPANY

631 Airport Road, Fall River, MA 02720