Lightolier A0302 Access to Junction BOX from below, Care and Maintenance of Alzak Reflector

INSTRUCTION SHEET NO.

IS:7784

A0302 Page 3 of 3

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To

assure full compliance with local codes and regulations, check with your local electrical inspector before

installation. To prevent electric shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

D. ACCESS TO JUNCTION BOX FROM BELOW			JUNCTION BOX
1)	Switch off power to fixture at service panel.	REFLECTOR
			JUNCTION BOX
2)	Remove CONE (Fig. 11) and LAMP.
3)	Locate SLIDE LATCH on HOUSING SUPPORT push	REFLECTOR	DOOR
	out to the right to disengage SLIDE LATCH from	SLOT
	SLOT of REFLECTOR (Fig. 12). Repeat for other two
	latches.

4)Push RFLECTOR up and to the side to provide access to JUNCTION BOX. (Fig. 12).

5)To access JUNCTION BOX, lift up JUNCTION BOX SPRING to remove JUNCTION BOX DOOR (Fig. 12).

6)After servicing, push all wires back inside JUNCTION BOX. Insert TABS of JUNCTION BOX DOOR into slots of JUNCTION BOX and align NOTCH of JUNCTION BOX DOOR with JUNCTION BOX SPRING. Snap JUNCTION BOX DOOR onto JUNCTION BOX firmly (Fig. 12 and 13). Make sure JUNCTION BOX DOOR is not pinching wires.

7)Install REFLECTOR back into HOUSING SUPPORT

(Fig. 13). For easier installation, the conduit from socket to junction box should be positioned as shown in Fig. 13.

8)Feel through the slots to align SLOTS of REFLECTOR with SLIDE LATCHES. Note: SLIDE

	LATCHES may not be visible from below, it is		SLIDE LATCH
	recommended to first align the slot with the latch
	opposite to junction box, then place REFLECTOR on
	inside of HOUSING SUPPORT (Fig. 13).
9)	Slide SLIDE LATCH to the left and pull back to
			HOUSING SUPPORT		FIG. 12
	secure REFLECTOR (Fig. 13). Repeat for the other					TAB
	two latches.
10)	To ensure REFLECTOR is properly secured, rotate
	REFLECTOR slightly to ensure SLIDE LATCHES		REFLECTOR	JUNCTION BOX
	engage with SLOTS in REFLECTOR. The			SPRING
	REFLECTOR should not rotate if it is in locked	SLOTS
	position.
11)	Install lamp.

12)Install CONE (Step C PG 2)

E.CARE AND MAINTENANCE OF “ALZAK” REFLECTOR

If handling of reflectors with anodized or Alzak finish is required, the use of clean white or plastic film gloves is recommended to avoid fingerprints.

Anodized or Alzak surfaces can be cleaned by the following methods:

1)Wipe off with a soft, clean, dry, lint-free cloth.

2)Wipe off with a soft, clean cloth dampened in mild detergent solution. Rinse, then wipe dry with a lint-

	free cloth or paper towel.
3)	Wipe off with a clean cloth dampened with a solution	HOUSING SUPPORT
	of wetting agent and water (such as 2 oz. per gallon)
	“Pluronic L62-F” by Wyandotte Products). Then wipe		FIG. 13
	dry.	SLIDE LATCHES
4)	Or use a liquid wash such as Glass Wax. Avoid
	gritty cleaning agents.
			A	COMPANY

631 Airport Road, Fall River, MA 02720