Lightolier A0302 instruction sheet Install and Wire Fixture, Push-In, To Remove

INSTRUCTION SHEET NO.

IS:7784

A0302 Page 2 of 3

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To

assure full compliance with local codes and regulations, check with your local electrical inspector before

installation. To prevent electric shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

NOTE: To insure proper installation it is important that MOUNTING FRAME always be securely mounted to structural ceiling members.

B. INSTALL AND WIRE FIXTURE

1) Install fixture in ceiling. Adjust fixture for proper alignment with the ceiling (Step A) and then wire fixture. White fixture lead to neutral supply lead. Bare fixture wire to supply ground. Use wire- nuts (local hardware items). Place all electrical connections in the J-BOX. Attach J-BOX COVER onto J-BOX.

NOTE: SLIDE LATCHES permit removal of reflector from within fixture for access to splices or for relamping from above ceiling (Fig. 8) These latches must be snapped back into position to prevent reflector from disengaging during relamping.

C. PUSH-IN (FIG.8)

1)Push APERTURE CONE or MULTI-GROOVE BAFFLE straight up into MOUNTING FRAME until tight against finished ceiling. RETAINING SPRINGS on MOUNTING FRAME (Fig.1) will secure APERTUR CONE or MULTI- GROOVE BAFFLE in place.

NOTE: To remove CONE or BAFFLE, turn CONE or BAFFLE counterclockwise while pulling downward. After starting, use both hands to remove, if desired. See (Fig. 11)

FIG. 8

FIG. 9

	TO REMOVE
FIG. 10

FIG. 11

A COMPANY

631 Airport Road, Fall River, MA 02720