Lightolier C4AICLV Is Ciclv, Installation Procedure For Low Voltage, A1099, Instruction Sheet No

Read and understand these instructions before installing fixture

This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To assure full compliance with local codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

INSTRUCTION SHEET NO.

IS:CICLV

A1099 Page 2 of 2

INSTALLATION PROCEDURE FOR LOW VOLTAGE

INSULATED CEILING (TYPE-1C) FRAME-IN-KITS: C4AICLV, C6AICLV

TRANSFORMER REPLACEMENT

• Make sure power to fixture is off.

• Remove REFLECTOR TRIM from ceiling by twisting counter-clock-

wise and pulling down.

• Disconnect & remove SOCKET HARNESS from TRANSFORMER

ASSEMBLY.

• Disconnect POWER SUPPLY HARNESS: For C4AICLV disconnect

harness at TRANSFORMER COVER. For C6AICLV disconnect har-

ness from junction box assembly (opposite side of fixture from

TRANSFORMER ASSEMBLY).

• Remove (2) THUMB SCREWS.

• Remove TRANSFORMER COVER from THUMB SCREW studs

• Pull TRANSFORMER ASSEMBLY and TRANSFORMER COVER into

TRANSFORMER COVER

TRANSFORMER CONNECTOR

THUMB SCREW

FIXTURE

HOUSING

TRANSFORMER

TRANSFORMER MOUNTING HARDWARE

TRANSFORMER

HOUSING

FIXTURE HOUSING and out through aperture opening.

• Disconnect TRANSFORMER wiring from THERMAL PROTECTOR(S)

and TRANSFORMER CONNECTORS. Refer to TRANSFORMER

WIRING DIAGRAMS shown below for your particular MODEL AS

INDICATED.

• Remove TRANSFORMER MOUNTING HARDWARE and discard faulty

TRANSFORMER.

• Install new TRANSFORMER in reverse order of removal.

WARNING: Risk of fire. Fixture contains THERMAL PROTECTORS that must be rewired as shown in DIAGRAMs below. Use only replacement TRANSFORMER obtained from LIGHTOLIER

TRANSFORMER ASSEMbLY

NOTE: 1. LOW VOLTAGE FIXTURES should be dimmed only with special dimmers intended specifically for that purpose. Use Lightolier Lytemode, Scenist, Crescendo VA, Neptune VA, Precision VA, EasySet VA, Sunrise VA, Radiant VA or equiva- lent products by others or variable autotransformers or elec- tronic dimmers intended for use with low voltage fixtures.

2.Low voltage fixtures produce audible sound which may be objectionable in acoustically critical areas.

		WHITE				WHITE	POWER
WHITE		BLACK		BLACK		BLACK	SUPPLY
						RED	CONNECTOR
WHITE				WHITE			(TO J-BOX)
THERMAL			THERMAL
		POWER SUPPLY					SOCKET
PROTECTORS			PROTECTORS		BLUE	WHITE
BLACK WHITE		HARNESS CONNECTOR		WHITE			HARNESS
					BLACK WHITE	WHITE
							CONNECTOR
	RED	WHITE		BLACK			5.5 V
					RED	WHITE	SOCKET
	RED	WHITE		RED	WHITE	WHITE
							HARNESS
PRI	SEC				PRI SEC		CONNECTOR
		SOCKET HARNESS					12 V
		CONNECTOR
TRANSFORMER
TRANFORMER WIRING DIAGRAM				TRANFORMER WIRING DIAGRAM
MODEL C4AICLV					MODEL C6AICLV

U.S. AND FOREIGN PATENTS PENDING

LIGHTOLIER a GENLYTE THOMAS company.

631 Airport Road, Fall River, MA 02720