READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To assure full compliance with local codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:1170
A0997 Page 2 of 2
EYEBALL ACCENTLITE 1.
Screw SOCKET EXTENSION (male adapter) into SOCKET. Note: Let EYEBALL HOUSING rotate freely.
2. SNAP-ON (Fig. B)
Insert SOCKET CUP in neck of EYEBALL HOUSING. Make sure SPRINGS of SOCKET CUP snap into SLOTS of EYEBALL HOUSING.
3. PUSH UP (Fig. C)
a. Rotate ROTO-CLIPS for proper REFLECTOR TRIM size.
For 7•11 (white reflectors 1170 Series and 1180 Series) the LONGER LEGS should extend inwardly toward the opening. Note: The LONGER LEG has a return on top (Fig. E)
b. Push EYEBALL HOUSING straight up until it is right against
SOCKET CUP
SOCKET EXTENSION
(Male Adapter)
EYEBALL HOUSING
ceiling.
“T” SLOT
Note: To remove EYEBALL portion of FIXTURE, pull down while twisting, then disconnect the SOCKET EXTENSION. Note: To remove EYEBALL HOUSING, turn EYEBALL HOUSING counterclockwise while pulling downward. To remove EYEBALL HOUSING from 1104 Series
SOCKET EXTENSION
SPRING CATCH
NOTE: To replace push EYEBALL HOUSING back into ceiling and connect the SOCKET EXTENSION into SLOT on top of EYEBALL. Insert one SPRING CATCH in EYEBALL into groove on bottom of HOUSING. Collapse SPRING CATCH on opposite side, push up and release, allowing second SPRING CATCH to snap into groove in EYEBALL HOUSING.
Fig. H
LONGER LEG
(Points Inward for 7•11
White Reflector Trim)
EYEBALL
RETURN
ROTO CLIP
Fig. I
WARNING: USE ONLY REFLECTOR TRIMS PROVIDED BY
LIGHTOLIER INC. USE OF OTHER MANUFACTURERS’ REFLECTOR
TRIMS VOIDS THE UNDERWRITERS LABORATORIES LISTING
AND COULD CONSTITUTE A FIRE HAZARD.
® |
