Lightolier IS:2000LV-A instruction sheet IS 2000LV-A, Airport Road, Fall River, MA, Frame-Inkits

READ AND UNDERSTAND THESE INSTRUCTIONS
	INSTRUCTION SHEET NO.
BEFORE INSTALLING LUMINAIRE.
installation. To prevent electric shock, turn off electricity at main power supply before proceeding.		IS:2000LV-A
This luminaire is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
Retain these instructions for maintenance reference.
		S0607	Page 1 of 2

INSTALLATION PROCEDURE FOR: LYTECASTER® 2000LV, 2000LVE1, & 2000LVE2 LOW VOLTAGE

FRAME-IN KITS

CAUTION: USE ONLY WITH REFLECTOR TRIMS PROVIDED BY LIGHTOLIER. USE OF OTHER MANUFACTURER’S TRIMS

MAY VOID THE UNDERWRITERS LABORATORIES LISTING AND COULD CONSTITUTE A FIRE HAZARD.

CAUTION: BEFORE INSTALLING FRAME-IN KIT AND REFLECTOR TRIM, READ ALL MARKINGS ON FRAME-IN KIT AND

REFLECTOR TO DETERMINE LAMP WATTAGE AND TYPE APPLICABLE FOR YOUR INSTALLATION.

WARNING— (RISK OF FIRE) DO NOT INSTALL INSULATION WITHIN 3 INCHES OF FIXTURE SIDES OR WIRING COMPARTMENT, NOR ABOVE FIXTURE IN SUCH A MANNER TO ENTRAP HEAT.

1.FRAME- IN AND WIRE-IN (Fig. A)

Fasten MOUNTING FRAME to wood joist. Line up bottom edge of ADJUSTABLE MOUNTING BAR with bottom of wood joist (Fig. E). Wire to supply leads. (For Cable, use built-in Cable Clamp in J-Box). WHITE FIXTURE LEAD to NEUTRAL SUPPLY LEAD. BLACK FIXTURE LEAD to HOT SUPPLY LEAD (120V). BARE FIXTURE WIRE to SUPPLY GROUND (2000LV only). Use wirenuts (local hardware item). Place all electrical connections in the J-BOX. Attach J-BOX COVER onto J-BOX.

NOTE: ADJUSTABLE MOUNTING BARS can be extended for 24” mounting. For suspended ceiling, make certain that the bottom of MOUNTING FRAME is no higher than 1” above ceiling line (Fig. F)

2.CLOSE- IN (Fig. B)

Install plasterboard, or any other dry type ceiling, as required. Hole in board must be cut either on the ground or after the board is nailed to the ceiling, using MOUNTING FRAME opening as a cutting guide. (Make sure ROTO- CLIPS are rotated out of hole area to be cut.) (Fig. G)

*Lightolier offers a hole cutter (HC-356) that can be purchased separately to assist with quick, clean trim installations. In this case, follow the hole cutting directions supplied with HC-356.

3.SNAP-IN (Fig. C).

→SEE SEPARATE REFLECTOR TRIM

4. PUSH- UP (Fig. D). INSTRUCTION SHEETS

NOTE: For wet plaster ceiling, use Plaster Ring Accessory

No.1959 (order separately).

SEE BACK PAGE FOR LAMPING INSTRUCTIONS.

A COMPANY

631 Airport Road, Fall River, MA 02720