Lightolier IS:2000LVNT Cf5-’-s0cK, Lytemode Scenlst, Crescendo VA, Neptune VA, ~.y,?

LAMPING

NOTE Socket manufacturers have suggested that socket may fail after 3 to 6 relampings. If this occurs socket can be replaced by disconnecting male connectors (attached to socket leads) from female connectors (attached to fixture leads) and replacing it with a naw socket procured thtiugh Lightolier (Fig H.).

1.Make sure that power is OFF when Iamping or relamping. Remove LAMP RING from SOCKET CUP by pulling etraight down.

2.Ineeft LAMP @fR-16) between LAMP

SPR NGS until face of lamp sits firmly on GLASS LAMP GUARD (Fig. l).

3, Attach SOCKET to hi-pin prongs on LAMP

4.Insert LAMP RING with LAMP and GLASS LAMP GUARD back into SOCKET CUF!

AIMING ANGLE ADJU=MENT (Fig. J)

~&OOOLVNT

Page 2 of 2

INSULATINGSLEEVING		MALECONNECTORS
		(Altaohedto socketWires
	--
+Q
~ FEMALE	CONNECTORS	MR16 SOCKET L
(Attached	to Fixture V4res)

FIG. H

cf5-’-s0cK

LAMP		- LAMP SPRING
	-#
GLASS LAMP		LAMP RING
GUARD	&

t

FIG. I

OCKET CUP

1.For vertical adjustment, insert blade of screwdriver into the open slot of YOKE.

2.Using the screwdriver as a lever, tilt the entire LAMP HOLDER to the desired angle.

3.~~L~#mtal adjustment, rotate tie LAMP

				LAMP HOLDER
NOTE 1.	LOW	VOLTAGE FIXTURES	should be	APERTURE TRIM
dimmed only wNh speciel dimmers intended				ASSEMSLY
specifically	for	that purpose. Use	Llghtoller	Yo
Lytemode Scenlst, Crescendo VA, Neptune VA,

Preclslon VA, Esayset VA, Sunriee VA, Redlsnt VA or

equivalent products by others ,or verieblo

sutotranaformera or electronicdlmmeraintendedfor use with low voltageflstuma.2. QW voltsgefixtures mey produoe eudible sound when ueed with dimme~ which may be objectional in acoustically

critical sreaa.

~,

~.

~.,

~.y::,?

FIG. J

NOTE Followthe mex. wire length recommended below to minimize voltsge drop. Voltage drop will

affect the brlghtneaa and color of the light.

~