Lightolier IS:2000LVRE1 Installation Procedure For, Instruction Sheet No, Page 2 of, IS 2000LVRE1

INSTALLATION PROCEDURE FOR:

Lytecaster® 2000LVRE1 Low Voltage Frame- In Kit

7.LAMPING (Fig. J)

1. Make sure that power is OFF when lamping or relamping. Remove LAMP RING from SOCKET CUP by pulling straight down.

2.Insert LAMP (MR-16 bulb) between LAMP SPRINGS until face of bulb sits firmly on GLASS LAMP GUARD (Figure J).

3.Attach SOCKET to bi-pin prongs on LAMP.

4.Insert LAMP RING with LAMP and GLASS LAMP GUARD back into SOCKET CUP.

NOTE: 1. LOW VOLTAGE FIXTURES should be dimmed only with special dimmers intended specifically for that purpose. Use Lightolier Lytemode, Scenist, Crescendo VA, Neptune VA, Precision VA, Easyset VA, Sunrise VA, Radiant VA or equivalent products by others or variable autotransformers or electronic dimmers intended for use with low voltage fixtures. 2. Low voltage fixtures may produce audible sound when used with dimmers, which may be objectional in acoustically critical areas.

8.ADJUSTMENT (Fig. K)

1.For vertical adjustment, insert blade of screwdriver into the open slot of YOKE.

2.Using Screwdriver as a lever, tilt the entire LAMP HOLDER to the desired angle.

3. For horizontal adjustment, rotate the LAMP HOLDER.

INSTRUCTION SHEET NO.

IS:2000LVRE1

A0607 Page 2 of 2

A COMPANY

631 Airport Road, Fall River, MA 02720