Lightolier IS:5543 instruction sheet IS5543, Instructions for Installation

READAND UNDERSTANDTHESEINSTRUCTIONSBEFOREINSTALLINGFIXTURE

sfixtureis intendedfor installationin acmrdanmwiththeNationalElectrical Code and IOCSIregulations. assure full mmpfiance with local @ales and regulations, deck with your Iocsl electrical inspector before ,allation. To prevent electrical shock, turn off electrify at fuse box before proceeding.

INSTRUCTION SHEET NO.

IS:5543

Retain these instructions for maintenance reference,1292 Page 1 of 1

INSTRUCTIONS FOR INSTALLATION

XTURE ASSEMBLY AND INSTALLATION:

1, Thread MOUNTING SCREWS intoOUTLET BOX.

2, Wtile supportingCEILING PAN make electrical connections black fixture lead or fixlurelead withouttracer marksto (hot) blacksupplylead; white fixturelead or fixturelead with tracer mark 10 (neutral)white supplylead. Uninsulatedwire is a groundand must be connectedto groundhg tarminalor groundlead inside OUTLET BOX, Use WIF?ENUTS(local hardware item). Push supply wires and wirenutmnnecfions back into OUTLET BOX.

3.PositionCEILING PAN over MOUNTING SCREWS and allowheadsof MOUNTING SCREWS tocome throughthe KEYHOLE SLOTS in CEILING PAN. Secure in place by tightening MOUNTING SCREWS,

4, Using the thrae AUXILIARY MOUNTING HOLES in CEILING PAN, secure CEILING PAN to ceiing using wood screws, toggle bolls, or alternate fasleners (not provided) depending on ceiling material,

5, lnstdl recommend lamps by inseiling base of lamp into SOCKET and snapping lamp into LAMP SUPPORT CLIP, CAUTION Use lamp waftage and type as marked on fixture,

6, Align holes in DIFFUSERRINGASSEMBLYwithMOUNTINGSTUDSonCEILINGPANandallowSTUDStopasslhroughlheholesSecure. in place bylhreadhg KNOBS onto each MOUNTING STUDS,

)IFFUSER CLEANING AND REMOVAL:

)iffusercan be cleaned using a soft damp cloth, Should DIFFUSER need to be removed

.om diffuser ring for cleaning, follow steps below.

Whie gently pving back on one RETAINING SPRING (use a slotted screw diver) push upon OIFFUSER allowing DIFFUSER to snap away from three RETAINING SPRING (Ffg, 2).

!.’ Clean DIFFUSER.

1,’ Reinsfdl DIFFUSER bygeotly pushing DIFFUSER down into DIFFUSER RING until all three RETAfNING SPRINGS engage on the edge of Ihe DIFFUSER and DIFFUSER sits flush inside DIFFUSER RING.

NOTE: If supply wires are located within three inches of ballast, use wire rated for at least 90° C.

WARNING-(RISK OF FIRE) MOST DWELLINGS BUILT BEFORE 1985 HAVE SUPPLY WIRE RATED 60” C. CONSULT A QUALIFIED ELECTRICIAN BEFORE INSTALLATION.

DIFFu

FIG. i

1.1<5I“ITC>I.EIla”EWH’,!W%YU