P
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
Thisfixture is intended for installation in accordance with the National Electrical Code and local regulations. To assure full complianm with local codes and regulations, check with your local electrical inspector before installation. Toprevent electrical shock, turnoff electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
I
5
INSTRUCTION SHEET NO.
IS:6074
ROI 93 | Page 1 of 2 |
INSTALLATION FOR AITACHING EXTENSION WAND TO LYTESPAN TRACK
FOR USE WITH LYTESPAN@TRACK SYSTEMS ONLY
Lytespot extension wand can be mounted on any Basic, Advent, Multipoint or Monopoint Track. It is intended for insulation on level ceilings only. Do not
mount on slope ceilings or walls unless when used with extension wand sloped ceiling adapter (6079WH, BK) ordered separately. Will fit Lytespot fixtures with Squat Adaptors, Low Voltage Adapters and Standard “T” Adaptors. NOTE: Do not exert sideward pressure on fixture,
NOTE: This Extension Wand is equipped with a flex joint to prevent damage by accidental impact. Heavy asymetric lighting equipment
should NOT BE used on this device.
1.Grasp FllllNG at top of EXTENSION WAND and insert it into the LYTESPAN TRACK. The LOCKING LEVER must be on the same side of the track as the BEAD, (See Fig. 1.)
2.Rotate the top FITTING 90° clockwise, )See Fig. 2), until LOCKING LEVER snaps and locks in place. (See Fig. 3.) Do not rotate wand from STEM or BOllOM HOUSING,
3.To Remove: Depress LOCKING LEVER; then rotate TOP FITTING 90°
LYTESPAN
TRACK
BEADFITTING
LOCKING
LEVERCLO
.1 | IG. 2 |
INSTRUCTIONS FOR CONVERTING Fll_llNG TO OPERATE ON 2 CIRCUIT TRACK SYSTEMS
See Fig. 4. BRASS CONTACT can be raised or lowered, Broken line indicates position for 1 circuit track or lower circuit of 2 circuit track system.
To convert attachment FllTING for upper circuit of 2 circuit track, raise BRASS CONTACT to high position by lifting CONTACT as high as stop permits and CONTACT clicks into place.
BRASS CONTACT
LOCKING
LEVER
FIG. 4
INSTRUCTIONS FOR AllACHING LYTESPOW FIXTURES USING SQUAT ADAPTER TO BOllOM OF LYTESPAN@ WAND
1.Insert the FIXTURE FITTING into the WAND SOCKET,
The LOCKING LEVER must start on the same side as the bead located at the bottom of the wand (See Fig. 5.) Rotate the FIXTURE FITTING 90° clockwise until LOCKING LEVER snaps and Iockd into place. (See Fig, 5,6, & 7).
2.To remove, depress LOCKING LEVER and rotate FllllNG 90° counterclockwise,
BEAD | BRASS CONTACT |
Lf~;~RG ~
\ a /
k,
CAUTION: SUPPORT THE LOWER WAND HOUSING WHENEVER MANIPULATING THE FIXTURE.
