
INSTALLATION OF CALCULITE
INSTRUCTION SHEET FOR ITEMS:
P7006, P7007, P7008, Q7006, Q7007, Q7008, R7029, R7030, R7031,0888 S7029, S7030, S7031, T7032, T7033, ~034, U7032, U7033, U7034
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.
This fixture is intended for installation in accordance with the National Electrical Code and local or federal code specifications. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance referance.
L MOUNTING SPRING
FIG. 1
I | OF FIRE)DO NOT iNSTALLlNsuLATlON wlTHIN3 INCHESOF FlxTuRE SIDESOR | I | |
WIRINGCOMPARTMENT,NOR ABOVE FlxTURE IN SUCH A MANNER SO AS TO ENTRAP HEAT. | |||
A. INSTALL INSIDE | REFLECTOR (FIG. 1) |
|
NOTE:For overlapping trim installation slip on WHITE TRIM RING over INSIDE REFLECTOR, as shown in Fig. 2 and 3. For flangeless trim installation, WHITE TRIM RING is not required.
1.To install INSIDE REFLECTOR in REFLECTOR/ HOUSING with SCREWS (Fig. 4), push INSIDE REFLECTOR up into REFLECTOR/HOUSING. Align keyslots in LOCKING RING and insert onto the SCREWS on REFLECTOR/HOUSING. Rotate INSIDE REFLECTOR clockwise so that CUT OUT WINDOW is always opposite the wall to be lighted. Now, tighten the SCREWS so that INSIDE REFLECTOR is held firmly against ceiling surface.
2.To install INSIDE REFLECTOR in REFLECTOR/ HOUSING with THUMB SCREWS (Fig. 5), push INSIDE REFLECTOR up into REFLECTOR/HOUSING. Rotate INSIDE REFLECTOR so that CUT OUT WINDOW is always opposite the wall to be lighted. Now, tighten the THUMBSCREWS so that INSIDE REFLECTOR is held firmly against ceiling surface.
B.CARE AND MAINTENANCE OF “ALZAK”
REFLECTOR
If handling of reflectors with anodized or Alzak finish is required, the use of clean white or plastic film gloves is recommended to avoid fingerprints.
Anodized or Alzak surfaces can be cleaned by the following methods:
;.Wipe off with a clean cloth dampened in mild detergent solution. Rinse, then wipe dry with
cloth or paper towel.
3.Wipe off with a clean cloth dampened with a solution of wetting agent and water (such as 2 oz. per gallon “Pluronic
WHITE | _“ |
TRIM |
|
RING |
|
FIG. 2 | FIG. 3 |
REFLECTORI
HOUSING
7
FIG. 4
|
|
| ....= |
|
| |
|
|
| I |
|
| ~ LOCKING RING |
|
| 9 |
|
| ||
REFLECTORI — |
|
|
|
| ||
HOUSING |
|
|
|
|
|
|
THUMBSCREW |
| i= |
|
| . ‘\\, |
|
CUT OUT |
| ‘ / |
| ‘< | INSIDE | |
|
| REFLECTOR | ||||
WINDOW |
|
|
|
|
| |
| ?~ |
|
|
| ||
|
|
|
|
| ||
|
| i |
| ~ | ||
|
|
|
| |||
|
|
| FIG. | 5 |
|
|
U.S. Pat. No. 4,039,822