Lightolier manual Lighting Systems PTS8-1, 1BHF

PG

, Module Ordering Information, Features

Lighting Systems PTS8-1

1BHF

PG

1FSJNFUFS
5SPVHI
3FDFTTFE
-JHIU
5
1FS
/PNJOBM
4FDUJPO

9 3/8" (23.81cm)

7"

(17.78cm)

Module Ordering Information

1 2 3

Quarter Scale

4

5 1/2" (13.97cm)

Family

PTS8

LampsShieldingVoltageLengthOptions

1

1 = 1 Lamp	O = Open	1 = 120V		2	= Two-Foot	Blank = No Options
	L = Lens	2 = 277V		3	= Three-Foot	A = Adjustable*
	S = Straight	3 = 347V		4	= Four-Foot	X4	= 4 thru wires
	Blade Louver	D1	= 120V Dim.	6	= Six-Foot	X5	= 5 thru wires
		D2	= 277V Dim.	8	= Eight-Foot	A4	= Adjustable 4 thru wires*
		E1	= 120V Emerg.			A5	= Adjustable 5 thru wires*
		E2	= 277V Emerg.

* only available on Two-Foot, Three-Foot and Four-Foot versions. See length variations of adjustable fixtures on page 2.

Features

1.Housing: Die-formed 20 gauge pre-painted steel. Integral heavy gauge bulk- heads support housing and trim, permitting modules to be bolted together in continuous runs and facilitate suspension.

2.Lamping: Cross-sectional one linear T8 fluorescent lamp. Provided by others.

3.Reflector: Precision parabolic roll-formed semi-specular aluminum.

4.Louver: Lift and shift straight blade louver constructed from die-formed alu- minum and painted to match housing. Louver blades are 1” (2.54cm) high on 1-1/8” (2.86cm) centers. (Optional)

Mounting

“J” Rail is first mounted to the wall and the modules connect to the rail for 1/4” (0.64cm) wall adjustment. Modules are hung from suspension wires attached to the fixture bulkheads and the structure above.

Electrical

Electronic Ballast: Programmed start, 3 conductor, 12 gauge wire. Color-coded quick connectors allow easy connection for modular fixutres. Factory installed ballast disconnect allows the ballast to be disconnected from and reconnected to incoming power under load without turning the entire circuit off.

Dimming: Advance Mark X, use Advance compatible two-wire control (no extra control lead required).

Emergency Battery Pack: 450 Lumens @ 90 minimum.

Ordering Instructions

Individual Fixtures:

1.Order number of MODULES required.

2.Order one END SET per MODULE.

Continuous Rows:

1.Determine run length.

2.Order the appropriate number of MODULES for the complete ROW.

3.Stagger rows must be completed with an adjustable module. (2-light only)

4.Non-stagger rows must be completed with an adjustable module unless row lengths are in precise 1 foot (30.48cm) intervals.

5.Order one END SET per ROW.

Labels

UL, cUL and IBEW

Job Information Type:

Job Name:

Cat. No.:

Lamp(s):

Notes:


"JSQPSU
3PBE
'BMM
3JWFS
."

t


t
'BY



We reserve the right to change details of design, materials and finish.

XXXMJHIUPMJFSDPN
½

1IJMJQT
(SPVQ
t %