READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

INSTRUCTION SHEET NO.

This fixture is intended for installation in accordance with the National Code and local regulations.

SH20330

before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

To assure full compliance with local codes and regulations, check with your local electrical inspector

 

 

Retain these instructions for maintenance reference.

Page 1 0f 2

 

INSTRUCTIONS FOR INSTALLATION OF AGILI-T FIXTURES

T-Bar

 

 

 

Support to Building

 

Structure

 

1/4-20 Screw

 

 

Suspension Kit

 

 

Mounting Clip

 

 

Canopy

 

Figure 1

Figure 2

 

 

 

1. Install mounting clip on T-Bar (Figure 1) and insert canopy onto suspension kit (Figure

Figure 3

2). Fasten Power Feed Suspension Kit or regular Suspension Kit to 1/4-20 screw

 

provided (Figure 2). Attach clips to upper deck when required by local code by inserting

 

support to building structure through the supplied holes (Figure 3).

 

Plastic End Cap

Aircraft Cable

Plunger

Mechanism

Aluminum

Joiner

Figure 5

Figure 4

Power Feed

Connection

2.Install luminaire temporarily by inserting die-cast aluminum joiner mechanism at the end of aircraft cables (Figure 5). into plastic end cap of fixture (Figure 4). Manually plug in power feed connection (plus 2 extra communication cables for Agili-T Network) when installing single luminare or first of a row (Figure 5).

3.Adjust height using aircraft cable plunger mechanism (Figure 5). Adjust level by sliding Aluminum Joiner sideways as needed (Figure 4). Final level adjustment can be performed before or after installing end-cap or next luminaire in a row.

525 Education Road, Cornwall K6H 6C7

Tel:(613)938-6221 Fax:(613)938-0961

Page 1

Rev.01

Page 1
Image 1
Lightolier SH20330 instruction sheet Power Feed Connection, Instructions for Installation of AGILI-T Fixtures