Lincoln 1628-000-A Conveyor motor, check for a frequency output from the hall effect, control

Conveyor motor	If there is voltage supplied to the hall effect sensor,
	check for a frequency output from the hall effect
	sensor. Measure frequency across the yellow and
	white wires at the motor connector. Frequency
	readings should be approx. 20 – 525 Hz. If these
	readings are not achieved, replace the conveyor
	motor. If the readings are achieved, proceed.
Oven control	If the hall effect sensor readings are correct, but there
	is no speed indicated on the display, replace the oven
	control.

8 Low Profile – 1600 Series Adv Dig Electric S.M. – Int’l