INSTALLATION | ||
|
|
|
Connection of the LN-7 to the Weldmark 225
•Shut the welder off.
•Connect the
•Place the “RANGE” switch to the “WIRE FEED” position and the “POLARITY” switch to the desired polarity.
•Place the “IDLER” switch in the “HIGH” idle position. The engine idling device may not function when welding in the “WIRE FEED” mode.
•Adjust wire feed speed at the
NOTE: If the output “CONTROL” is set below “3” the K240 contactor may not pull in.
Connection of K930-[ ] TIG Module to the Weldmark 225.
The TIG Module is an accessory that provides high frequency and shielding gas control for AC and DC GTAW (TIG) welding. See IM528 supplied with the TIG Module for installation instructions.
NOTE: The TIG Module does not require the use of a high frequency bypass capacitor. However, if the Weldmark 225 is used with any other high frequency equipment, the bypass capacitor must be installed - order kit T12246.
INSTRUCTIONS
Additional Safety Precautions
Always operate the welder with the roof and case sides in place as this provides maximum protection from moving parts and assures proper cooling air flow.
Read and understand all Safety Precautions before operating this machine. Always follow these and any other safety procedures included in this manual and in the Engine Owner’s Manual.
Welder Operation
Welder Output
•Maximum Open Circuit Voltage at 3700 RPM is 80 Volts RMS.
•Duty Cycle: 100% for both welding and auxiliary power.
Weldmark 225
Constant Current | 225 Amps AC @ 25 Volts |
|
| 210 Amps DC @ 25 Volts | |
|
|
|
Constant Voltage | 200 Amps DC @ 20 Volts | |
|
|
|
Auxiliary Power
The WELDMARK 225 can provide up to 8,000 watts of 115/230 volts AC, single phase 60Hz power for continuous use. The front of the machine includes three receptacles for connecting the AC power plugs; one 50 amp 115/230 volt NEMA
CAUTION
Do not connect any plugs that connect to the power receptacles in parallel.
Start the engine and set the “IDLER” control switch to the desired operating mode. Set the “CONTROL” to
10.Voltage is now correct at the receptacles for auxil- iary power.
115/230 Volt Dual Voltage Receptacle
The 115/230 volt receptacle can supply up to 35 amps of 230 volt power to a two wire circuit, up to 35 amps of 115 volts power from each side of a three wire cir- cuit (up to 70 amps total). Do not connect the 115 volt circuits in parallel. Current sensing for the automatic idle feature is only in one leg of the three wire circuit as shown in the following column.
WELDMARK 225
