Wire Feed Module (K623-1) - Provides constant
voltage (CV) output with improved arc stability for Innershield welding. Excellent for MIG welding. Recommended wire feeders are the LN-7, LN-23P and LN-25. (Factory installed on the K1643-2).
LN-25 Wire Feeder K449-Portable CC/CV unit for flux-cored and MIG welding. Includes Gas Solenoid & Internal Contactor. Requires Wire Feed Module.
Remote Voltage Control Kit for LN-25 K444-2Provides 25 ft. (7.5m) of remote output voltage control and output jumper (2 and 4) for machines having 14 pin MS-type connector.
Magnum® 350 Innershield Gun (for LN-25)K126-2- For self-shielded wire with 15 ft. (4.5m) cable. For
.062-3/32” (1.6-2.8mm) wire.
Magnum® 200 MIG Gun (for LN-25)K497-3-With 15 ft. (4.5m) cable. For .025 (0.6m) wire.
Magnum Gun Connector KiT-Connects Magnum 200 MIG gun to LN-25 Wire Feeder.
LN-23P Wire Feeder K316L-1-Portable CV unit for Innershield pipe welding. Control cable operates con- tactor inside Wire Feed Module for “cold” electrode. Requires LN-23P Adapter Kit (K350-1) and Gun and Cable Assembly.
LN-23P Adapter Kit K350-1-Required to adapt LN- 23P to any Lincoln power source. Makes 14 pin con- nection at power source.
Magnum® 250 Innershield Gun (for LN-23P) K355- 10-For lighter weight and easier handling. Rated 250 amps, 60% duty cycle. For .068 through 5/64” (1.7 through 2.0 mm) Innershield wire and includes reduced speed switch. For pipewelding, an M11476 62° gun tube is recommended.
62° gun tube for Pipe Welding KP1909-1- Recommended modification for K355-X or K345-x guns with 90° gun tubes. Compatible with K126-1,- 2,K264_8 and K355-10.
SPOOL GUN WELDER
Magnum Spool Gun K487-25-Hand held semiauto- matic wire feeder requires SG Control Module. 25 ft. length.
SG Control Module K488-The interface between the power source and the spool gun. Provides control of wire speed and gas flow.
Input Cable K691-10.-For Lincoln engine drives with 14-pin MS-type connection, separate 115V NEMA receptacle and output stud connections. 10 ft. length.
