![](/images/new-backgrounds/1258501/25850135x1.webp)
INSTALLATION | ||
|
|
|
INSTALLATION
The
The Carriage Release Handle, the Wire Reel Support Bracket and the Wire Drive Support Bracket are not factory mounted. They should be mounted to the car- riage before it is placed on the beam per the following instructions.
1. Insert the clutch handle into the hole on the right side of the carriage so that the end of the handle is goes into the lift yoke.
2. Line up the hole in the handle and the hole in the lift yoke and insert the roll pin that came taped to the handle. Drive in the roll pin until it is flush with the yoke.
3. a. If the MAXsa™ 10 Control Box going to be mounted on the carriage, mountis notthe Wire Reel Support Bracket to the left front corner of the carriage using the hardware provided.
b. Do not mount the Wire Reel Support if the
Do not mount the
riage is placed on the beam.
4. Install the Wire Drive Mounting Bracket that is sup- plied with the MAXsa™ 22, using the hardware and insulators provided. See Figure A.6.
To install a MAXsa™ 29 Wire Drive order a NOTE: Mounting Bracket (M6769) and the appropri-
ate Head Support (K29 or M8232).
5. Use an ohmmeter to be sure that the Wire Reel shaft and the Wire Drive Mounting Bracket are electrically isolated from the
With the release handle all the way down, set the car- riage on the beam. It should run freely along the beam. With the release handle in the up position the drive gear should engage the track and hold the car- riage securley in position.
If the MAXsa™ 10 Control Box is to be mounted to the
1. Attach the
Make certain that there is enough clearance to NOTE: the left of the beam to accomodate the K2462-
1 bracket
2. Mount the MAXsa™ 10 Control Box to the brack- et and connect the 4 pin connector from the Travel Control to the mating receptacle on the bottom of the MAXsa™ 10 Control Box.
Keep the load on the
After all of the equipment has been mounted to the carriage, the tracking of the drive gear and the bear- ings should be checked.
FIGURE A.6 - WIRE DRIVE MOUNTING
Wire Reel
Mounting Bracket
MAXsa™ 10
Mounting Bracket
Clutch | Wire Drive Mounting |
Handle | |
| Bracket (M6769) |
Head Support
(M8232)