Lincoln Electric IM597 manual Maintenance, Testing The Torch, Section, Cc Posa Start Operation

Section 8

7.3.3 CC POSA START OPERATION

Attach the Cobramatic® to a CC power source according to the installation instructions.

Insure power supply high frequency switch is in the “OFF” position, and power supply is set to DC reverse polarity.

The power supply contactor should be set to “Remote” or “Tig” and the amperage control set to “Panel” or “Standard” depending on power supply. Turn the Cobramatic® power switch to the “ON” position and the Posa Start switch to the “OFF” position.

Adjust power source to desired amperage for your weld condition.

Press gun trigger and adjust wire feed speed at gun to match current setting. If approximate wire feed speed is not known, it is better to start with excess wire feed rather than too little, in order to prevent possible damage to the contact tip.

Turn Posa Start switch to the “ON” position. Press torch trigger and, using Run-in Speed Control, adjust wire feed speed to approximately 10% of welding wire speed set at torch.

Strike an arc; if the wire stubs out, reduce wire feed rate at gun, or increase amperage setting on power source.

NOTE: Because the Posa Start Run-in Speed always remains a percentage of the actual welding wire feed rate, the Posa Start run-in speed will always slow down or speed up proportional to any adjustment you now make at the gun. Therefore, if you slow down the welding wire feed speed, you will have to increase the Run-in Speed setting.

MAINTENANCE

Maintenance of the torch will normally consist of a general cleaning of the wire guide system, including tubes, drive rolls, and conduits at regular intervals.

Remove spatter build-up from inside of nozzles with a hardwood stick.

The only parts on the Cobramatic system that are subject to normal wear are the conduit, contact tips, gas cups, front body liners, wire guides, drive and idler rolls. A supply of these parts should be maintained on hand.

If repairs do become necessary, any part can easily be replaced by a qualified shop maintenance man.

Your Cobramatic® is designed to provide years of reliable service. Normal wear and component failure may require occasional service.

The number of units in operation and the importance of minimal "down time" will determine to what extent spare parts should be stocked on hand.

8.1 TESTING THE TORCH

8.1.1 MOTOR CHECK

Remove the amphenol connector from the cabinet.

Using the torch amphenol, check the resistance across pins “A” and

“B”(motor leads). The resistance across the motor should be between 5-10 ohms.

If an open circuit or short exist, check the motor leads and motor independently.

K1587-1 Cobramatic® Owner's Manual - Page 14