Troubleshooting
If you have any trouble using the AV receiver, look for a solution in this section. If you can't resolve the issue yourself, contact your Onkyo dealer.
If you can't resolve the issue yourself, try resetting the AV receiver before contacting your Onkyo dealer.
To reset tile AV receiver to its factory defaults, turn it on and, while holding down VCR/DVR, press
ON/STANDBY. "Clear" will appear on the display and the AV receiver will enter Standby mode.
VOR/DVR
N When the power is restored after a power interruption, "CHECK SP WIRE" appears on the display
The protection circuitry has been activated.
Remove the power cord fl'om the wall outlet
immediately. Disconnect all speaker cables and input sources, and then leave the AV receiver with
its power cord disconnected for 1 hour. After that,
reconnect the power cord and set the volume to
maximum. [f the AV receiver stays on, set then the
volume to minimum, disconnect the power cord, and
reconnect your speakers and input sources. If the AV receiver turns off when you set the volume to
maximum, disconnect the power cord, and contact your Onkyo dealer.
Note that resetting the AV receiver will delete your radio presets and custom settings.
} Remote indicator
RECEIVER
i HOME
To reset the remote controller to its factory defaults, while holding down RECEIVER, press and hold down HOME until the remote indicator lights (about 3 seconds). Within 30 seconds, press RECEIVER
again.
N Can'tturn on the AV receiver
Make sure that the power cord is properly plugged
into the wall outlet.
N There's no sound, | or it'svery | quiet |
| |
Make sure | that the digital | input source | is selected | 35 |
properly. |
|
|
|
|
Make sure that the inputs and outputs of all | ||||
| ||||
components | are connected | properly. |
|
|
Make sure that the input source is properly selected. 19
Check the volume. The AV receiver is designed for 19
home theater enjoyment. It has a wide volume range,
allowing precise adjustment.
While a | pair of | headphones | is connected | to the | 33 |
PHONES | jack, | no sound | is output from | the |
|
speakers. |
|
|
|
|
|
Check the digital audio output setting on the
connected device. On some game consoles, such as those that support DVD, the default setting is off.
If your | turntable | uses | an MC | cartridge, you must | 15 |
connect an MC head amp, or an MC transformer. |
| ||||
Not all | listening | modes | use | all speakers. | 27 |
N The AV receiver turns off unexpectedly
Make sure that the speaker setup microphone is not
When the set Auto Standby starts running, the AV 41
receiver will automatically go standby.
EB
still connected.
50