Onkyo HT-R590 menu _ page, Tone Control Settings, Speaker Levels, Audyssey, m Subwoofer Level*l

mLipSync Off On

This function allows the AV receiver to automatically correct any delay between the video and the audio, based

on the data from the connected monitor.

•This function works only if your HDMl-compatible TV supports HDM[ Lip Sync.

After changing the settings of the "HDMI Ctrl

(RIHD)", "HDMI Through" or "Audio Return Ch", turn off the power to all connected pieces of equipment and then turn them on again. Refer to the instructions for all connected pieces of equipment.

You can change various audio settings from the Home

menu (_ page 31).

1 Press RECEIVER followed by HOME.

2 Use &/, and ENTER to select "Audio", and then

use l/¥/_/_ to make the desired selection.

!

•These settings are not available ill either of the following cases:

-a pair of headphones is connected.

-the "Audio TV Out" setting is set to "On" (_ page 42) and all input selector other than HDM[ is selected.

-"HDMI Ctrl (RIHD)" is set to "On" (_ page 42) and you're listening through your TV speakers.

Tone Control Settings

IBass

-10 dB to 0 dB to +10 dB in 2 dB steps

You can boost or cut low-frequency sounds output from the front speakers.

mTreble

-10 dB to 0 dB to +10 dB in 2 dB steps

You can boost or cut high-frequency sounds output from the front speakers.

You can adjust the bass and treble for the front speakers, except when the Direct listening mode is selected.

Speaker Levels

m Subwoofer Level*l

-15 dB to 0 dB to +12 dB in 1 dB steps

m Center Level

-12 dB to 0 dB to +12 dB in 1 dB steps

You can adjust the volume of each speaker while listening to an input source.

These temporary adjustments are cancelled when the AV receiver is set to Standby. To save the setting you made

here, go to "Level Cal (Level Calibration)" (_ page 37) before setting the AV receiver to Standby.

•You cannot use this function while the AV receiver is muted.

•Speakers that are set to "No" or "None" in the "Sp Config (Speaker Configuration)" (_ page 36) cannot be adjusted.

"1 This procedure can also be performed on the AV receiver by using its SUBWOOFER LEVEL.

Audyssey

mAudyssey

See "Audyssey" of "Source Setup" (_ page 39).

m Dynamic EQ

See "Dynamic EQ" of"Source Setup" (_ page 39).

m Dynamic Volume

See "Dynamic Volume" of "Source Setup" (_ page 39).

•These technologies can be used when all the following conditions are met:

-Room Correction and Speaker Setup is completed. Note that

"Audyssey" requires the "Audyssey 2EQ Full Calibration" method.

-Any listening mode other than Direct is selected.

-A pair of headphones is not connected.

-The input selector other than USB is selected.

•The setting is stored individually for each input selector.

Operating on the AV receiver

1Press TONE on the AV receiver repeatedly to

select either "Bass" or "Treble".

2Use + and - on the AV receiver to adjust.

•To bypass the bass and treble tone circuits, select the Direct listening mode.

Ell

43