Onkyo HT-R590 Error Messages, Changing the Speaker Setup Manually, Using a Powered Subwoofer

Error Messages

While Audyssey 2EQ® Room Correction and Speaker Setup is in progress, one of the error messages below may appear.

q

f'_;,;_,;;;,i'_;ig;;i;'o'_,i_;'i@-- Error message

Cancel

The options are:

Retry:

Try again.

Cancel:

Cancel Audyssey 2EQ Room Correction and Speaker Setup.

• Ambient noise is too high.

The background noise is too loud. Remove the source of the noise and try again.

• Speaker matching error!

The number of speakers detected was different from

that of the first measurement. Check the speaker connection.

• Writing Error!

This message appears if saving fails. Try saving again. If this message appears after 2 or 3 attempts, contact

your Onkyo dealer.

•Speaker Detect Error

This message appears if a speaker is not detected. "No" means that no speaker was detected.

•See "Speaker Configuration" for appropriate settings (÷ page 12).

Changing the Speaker Setup Manually

You can manually make changes to the settings found

during Audyssey 2EQ Room Correction and Speaker Setup.

See also:

• "Sp Config (Speaker Configuration)" (_ page 36)

• "Sp Distance (Speaker Distance)" (_ page 37)

• "Level Cal (Level Calibration)" (_ page 37)

Using a Powered Subwoofer

If you're using a powered subwoofer and it outputs very

low-frequency sound at a low volume level, it may not be

detected by Audyssey 2EQ Room Correction and Speaker Setup.

If the "Subwoofer" appears on the "Review Speaker

Configuration" screen as "No", increase the subwoofer' s volume to the half-way point, set it to its highest crossover

frequency, and then try running Audyssey 2EQ Room

Correction and Speaker Setup again. Note that if the volume is set too high and the sound distorts, detection

issues may occur, so use an appropriate volume level. If

the subwoofer has a low-pass filter switch, set it to Off or

Direct. Refer to your subwoofer's instruction manual for details.

ED

26