MAINTENANCE | ||
|
|
|
For K1722:
Connect the black lead and the white lead to the gun trigger. Connect the other leads to the rocker switch leads. (See Figure E.5).
STRAIN RELIEF |
| SWITCH | ||
|
|
| ||
|
| CABLE ASSEMBLY | ||
STRAIN RELIEF |
| SWITCH WIRES | ||
| ||||
HOUSING |
|
|
| |
CABLE BOOT |
|
|
| |
|
|
|
|
|
|
|
|
|
|
T0 RED LEAD
TO BLUE LEAD GUN TUBE
GUN HOUSING
TRIGGER ASSEMBLY
TRIGGER WIRES
Figure E.5
j)Position the cable boot and strain relief on the cable so it fits in cable handle cavity and lock the strain relief in place by pushing the two halves together.
k)Assemble cable in left side of gun handle. Assemble trigger into the proper handle cavity.(For K1722 also assemble the rocker switch in the groves provided in the handle.) Assemble right side of gun handle and tighten the screws that hold the handle together. (See Figures E.4 and E.5).
WIRE FEEDER END REPAIR (K574 AND K1722)
a)Remove the cable liner per previous instructions.
b)Remove the feeder end connector, molded gas plug (or barbed fitting), cable handle nut, plastic tailpiece, and connector cover (See Figure E.6).
NOTE: In order to remove the cable handle nut, the tail of the connector cover must be depressed and the cable handle nut rotated 1/4 turn counterclockwise as viewed from the feeder end.
4.68 | (119mm) |
|
| PRESS HERE TO | CONNECTOR COVER |
| REMOVE THE CABLE |
|
| HANDLE NUT |
|
.43 (11 mm) MAX
Figure E.6
MAGNUM® 400 DUAL PROCEDURE GUNS
