Lincoln Electric IM665 manual Output Connections, Torch

A-4 INSTALLATION A-4

NOTE: When using nitrogen gas from a cylinder, the cylinder must have a pressure regulator.

•Maximum psi from a nitrogen gas cylinder to the PRO-CUT 25 regulator should never exceed 150 psi.

•Install a hose between the nitrogen gas cylinder regulator and the PRO-CUT 25 gas inlet

.

CYLINDER could explode if damaged.

WARNING

• Keep cylinder upright and chained to a fixed support.

• Keep cylinder away from areas where it could be damaged.

• Never lift machine with cylinder attached.

•Never allow the cutting torch to touch the cylinder.

•Keep cylinder away from live electrical parts.

•Maximum inlet pressure 150 psi.

__________________

OUTPUT CONNECTIONS

Torch

The PRO-CUT 25 is sent from the factory with a 15’ PCT 20 cutting torch installed. Additional cutting torch- es can be ordered from the K1615 series. Hand-held torches come with 15' or 25’ cables.

Read and understand this entire section before oper- ating the machine.

PRO-CUT 25