Lincoln Electric IM794 Safety Precautions, Identify And Locate Components, Installation, SP-170T

A-2 INSTALLATION A-2

SAFETY PRECAUTIONS

Read entire installation section before starting installation.

WARNING

ELECTRIC SHOCK can kill.

•Only qualified personnel should perform this installation.

•Only personnel that have read and under- stood the SP-170T Operating Manual should install and operate this equipment.

•Machine must be plugged into a receptacle which is grounded per any national, local or other applicable electrical codes.

•The SP-170T power switch is to be in the OFF (“O”) position when installing work cable and gun and when connecting power cord to input power.

IDENTIFY AND LOCATE

COMPONENTS

If you have not already done so, unpack the SP-170T from its carton and remove all packing material around the SP-170T. Remove the following loose items from the carton (see Figure A.1):

1.SP-170T

2.Gun and cable assembly(1)

3.Literature and miscellaneous including:

a)This operating manual

b)A separate .030" (0.8 mm) contact tip

c)Hex key wrench for removal of drive roll.

4.10 ft (3,0 m) work cable.

5.Work clamp.

6.2lb. Spool of Super Arc L-56 .025 MIG Wire.

7.Adjustable mixed-Gas Regulator & Hose.

(1)The gun is ready to feed .023" – .025" diameter wire.

FIGURE A.1

1

2

WEL
DING		AMP
25-			RANGE
	125

4

3

6

5

7

SP-170T