COUGAR™ Push Pull Gun - OPERATING INSTRUCTIONS
Safety Precautions
• Do not touch electrically live parts or electrode with skin or wet clothing
• Insulate yourself from work and ground.
• Always wear dry insulating gloves.
• Keep your head out of fumes.
• Use ventilation or exhaust to remove fumes from breathing zone.
• Keep flammable material away.
• Do not weld on containers that have held combustibles.
• Wear eye, ear and body protection..
WARNING: Electric shock can kill. Fumes and gases can be dangerous to your health. Arc rays can injure eyes and burn skin. See additional warning information under "Arc Welding Safely Precautions" on inside of front cover of operating manual. When inching, (the electrode and drive mechanism are always electrically energized and remain energized several seconds after the gun trigger is released.
Setup Procedure
Selecting Electrode Wire
Several alloy types of filler metals are available, and the best choice depends on the type of base metals and the desired characteristics of the weldment, such as ductility and strength, corrosion resistance, sustained service temperature, and anodic treatment color matching. In addition, several wire sizes are available, and the choice here will depend upon several fac- tors, including base metal thickness and the arc transfer process
used. Consult your local dealer or appropriate AWS publication for help in selecting an appropriate alloy type and wire size. Also refer to, "Procedure Settings" later in this chapter, for wire sizes used with typical base metal thicknesses and procedure set- tings.
Installing Conduit Liner:
1.Laying torch out straight remove positioning nut, then insert your liner, tapered end first, all the way into torch until it stops. NOTE: You should see the liner through the holes in the inlet guide this will help make sure liner is fully installed.
Inlet Guide with Liner
Inspection Hole
Liner Positioning
Nut
2.While torch is still laying out straight adjust your
Positioning Nut | Collet |
3.Reinstall the positioning nut securely, then trim rest of liner flush with positioning nut, accordingly to fit up to drive rolls.
Installing Barrel Liner
1. Unscrew barrel inlet guide
2. Unscrew barrel liner from inlet guide
3. Reverse procedure with new liner. Be sure to install liner with tapered end toward contact tip, and liner is fully threaded into inlet guide.
Neck Barrel
Torch Liner Inlet
BarrelGuide
5
