V300-PRO
INSTALLATION
A-6 A-6
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
OUTPUT CABLES
Select the output cable size based upon the following
chart.
Cable sizes for Combined Length of Electrode and
Work Cable (Copper) 75° rated:
Duty Length Up 61-76m
Cycle Current 61m (200 ft.) (200-250 ft.)
100% 250 1/0 1/0
60% 300 1/0 2/0
QUICK DISCONNECT PLUGS (K852-7)
Aquick disconnect system is used for the welding
cable connections. The welding plug included with the
machine is designed to accept a welding cable size of
1/0 to 2/0.
1. Remove 1 inch (25mm) of welding cable insulation.
2. Slide rubber boot on to the cable end. The boot
end may be trimmed to match the cable diameter.
Soap or other lubricant will help to slide the boot
over the cable.
3. Slide the copper tube into the brass plug.
4. Insert the cable into the copper tube.
5. Tighten set screw to collapse copper tube. The
screw must apply pressure against welding cable.
The top of the set screw will be well below the sur-
face of the brass plug after tightening.
6. Slide the rubber boot over the brass plug. The rub-
ber boot must be positioned to completely cover all
electrical surfaces after the plug is locked into the
receptacle.
25 mm
1 in.
WELDING CABLE
BOOT
TRIM
SET SCREW
BRASS PLUG
COPPER TUBE
reverse 25mm & 1in